Kitchen worktops in Camden Town

Yes. Heavy flat-conversion territory, so a lot of kitchens are the rear half of a first-floor conversion or a lower-ground room off a light well, which keeps runs to 2.4-3.2m single-wall or a shallow L with the sink under the window. Whole-house jobs are rarer than up the hill, and when they happen it is usually a rear knock-through with a 3m run and a peninsula rather than a full island. A red route means no stopping, and no stopping means exactly that, so the stone comes in from a side street or from a bay behind the property. The templating visit needs somewhere to stop for two or three hours, which is a different problem from unloading for twenty minutes. It goes on the job sheet for the fitting crew.

early Victorian terrace, Georgian-style stucco terrace, post-war ex-local-authority block and canal-side new build. A villa cut into flats leaves kitchens in rooms that were never kitchens, with services run to wherever they could physically be made to reach. Victorian party walls and chimney-breast returns bow along their length, so the template plots the real line rather than assuming a straight one - the template picks up points every few hundred millimetres down the back of the run and the drawing carries that curve through to the saw. Recorded as it is, not as it was drawn.

The CPZ runs seven days near the markets, the streets around the Lock are pedestrianised or clogged with market traffic until late, and Camden Road and Kentish Town Road are constant bus routes with nowhere to sit a van. Most drops are a shared front door then a turn onto a narrow converted landing, so a 3m slab often cannot be carried flat past the newel post. A walk-up with winders at every half-landing means the piece is rested and re-gripped on the way, so the crew size goes up before the piece size comes down. The templater measures that route on the same visit, so the drawing leaves site already knowing the maximum piece. It goes on the drawing with the run dimensions.

Worktop replacement, worktop templating and worktop installation, in that order. In a converted house the flat entrance and the internal doorway are usually tighter than the communal stairs, and that is easy to overlook. Where the window is fixed there is no second day to fall back on, so the prep list matters more than usual. One visit, done properly. Expect to plan a join purely to get material up a converted staircase, and check the floor first because conversion floors above a shop or a pub bounce more than you want under 30mm quartz.

Galley runs are usually short enough to come out of a single slab, so the material band you choose does more to the total than the room shape does. A layout templated off one wall instead of one datum will not sit right once all the pieces are down together. One datum for the whole room. Window boards and cills stand proud of the plaster, so the back edge of the top has to be plotted to where the units actually sit rather than to the wall. The old top has been hiding it, so the first honest look at it happens when the laminate comes off. The laminate has been covering it up. Material runs from £110 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines rather than rolled into one figure.

Where ownership is split across a building, the common parts belong to someone else and the carry route is negotiated rather than assumed. The fitting day is arranged with whoever can actually give us access for the whole slot. Protection goes down first. Tell us the building when you book and the lift, the stair turn and any freeholder notice get built into the day rather than found on it.