Worktop fabrication in Catford

Yes. Catford is on the patch, and the postcodes we work here are SE6. It is worked on our south east London run, along with the rest of Lewisham. Bay bookings are usually an hour or two, which is fine for unloading and no use at all as a place to leave the van for a day. It rarely changes what we cut, but it does change how the pieces are stacked and strapped for the run out. The load plan follows from it. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

A villa cut into flats leaves kitchens in rooms that were never kitchens, with services run to wherever they could physically be made to reach. Pieces are sized to the tightest turn on the route before anything is nested to the slab. The bench proves it before the van moves. Flats over the shops around the Broadway almost always mean a stair carry and a jointed run, price that in rather than discovering it on the day.

A one-way system and two stations funnel traffic tightly through the centre with loading restrictions on the main roads; the residential streets are permit-parked and narrow. A walk-up with winders at every half-landing means the piece is rested and re-gripped on the way, so the crew size goes up before the piece size comes down. So the nesting is worked to the measured route first and to the slab second. It is settled on the bench, not on site.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop replacement, worktop templating and worktop installation. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. In a converted house the flat entrance and the internal doorway are usually tighter than the communal stairs, and that is easy to overlook. Cutting several kitchens from different slabs and calling them matched is where firms get caught out. Proven on the bench before dispatch. Party-wall and lease conditions in a converted building set when noisy work can happen, which shapes the fitting day more than the kitchen does. So the nesting is planned around it rather than around a standard kitchen. Nested for the job in front of us.

The catch with a galley is that both runs are seen end-on from the doorway, so any difference in overhang between the two reads immediately. The nest is laid out around that, with joins placed over cabinet gables and kept clear of every cut-out. That is nested before any glass goes on the saw. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Where a corner is a couple of degrees off, a mitre cut to a theoretical ninety degrees opens on the wall side and there is no closing it afterwards. The template drawing carries the real geometry through to the saw, and the piece is machined to it rather than trimmed to it later. The drawing decides it, not the fitter. The sink and hob need to be on site and the run layout fixed before we start cutting, because moving a hob after the join position is set means recutting the whole piece. Where a landlord or housing provider is involved there is a specification to meet and a process to follow, and both are settled before a date is offered. The workshop works from the approved drawing, so whoever signs it off is signing off the join positions too. Changes cost a piece, not a tweak.