Worktop fabrication in Hither Green

Yes. Hither Green is on the patch, and the postcodes we work here are SE13, SE12. It is worked on our south east London run, along with the rest of Lewisham. Enforcement zones rarely accept a trade van unloading stone as an exemption, so this gets sorted before the date is confirmed rather than argued about afterwards. Where unloading has to happen in one go, the load order is planned so nothing has to come off twice. The load plan follows from it. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Wider halls make the carry noticeably easier, and that alone can remove a join that a narrower terrace would have forced into the run. Pieces are sized to the tightest turn on the route before anything is nested to the slab. The bench proves it before the van moves. Repeating house types make it predictable, but those side passages are typically under 800mm, measure before assuming a slab goes round the back.

Long straight residential streets with permit parking and no off-street spaces, but most houses have a side alley or shared passage to the rear which is often the better route into an extension. Rear access usually lets us fit longer pieces whole, so the join count ends up decided by the slab rather than by the building. The maximum piece length is fixed at drawing stage and every join is placed over a cabinet gable from there. It is settled on the bench, not on site.

It is one of the three we do most here, behind worktop installation. Same template visit, same workshop, same installers either way. Extension kitchens are usually specified long before they are buildable, so the run lengths on the drawing and the run lengths in the room are different numbers. So the nesting is planned around it rather than around a standard kitchen. Same slab run, or it is not a match. Rear and side-return extensions are where the islands appear, and an island is the piece that decides whether one slab does the kitchen or two. Pieces are dry-assembled and checked on the bench before anything is loaded. Proven on the bench before dispatch.

On a heavily veined stone the island and the run behind it are nested off the same area of slab so the movement relates across the room. Pieces are dry-assembled on the bench before dispatch so the corners are known to close before they leave the workshop. Every join sits over a gable. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Where a corner is a couple of degrees off, a mitre cut to a theoretical ninety degrees opens on the wall side and there is no closing it afterwards. The template drawing carries the real geometry through to the saw, and the piece is machined to it rather than trimmed to it later. The drawing decides it, not the fitter. The sink and hob need to be on site and the run layout fixed before we start cutting, because moving a hob after the join position is set means recutting the whole piece. The same building type can arrive as a careful one-off kitchen or as a fast turnaround, and the honest answer is that they are priced differently. The workshop works from the approved drawing, so whoever signs it off is signing off the join positions too. The approved drawing is the instruction.