Worktop templating in Chelsfield

Yes. Chelsfield is on the patch, and the postcodes we work here are BR6. It is worked on our south east London run, along with the rest of Bromley. A drive that shelves towards the house needs the van chocked and the trolley controlled, since a loaded A-frame gathers speed quickly on a slope. A templater circling for a space arrives late into a slot that was already tight, and the drawing is what suffers. Two hours is the realistic figure. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

A range or an Aga in an original recess is usually immovable, so the run is designed around it and the clearances come from the appliance. The island is templated for its overhang, its support and the position of the hob or sink within it, with sockets and any pop-up left where they will genuinely be. No stone is ever cut from a plan. Unmade private roads here shake a loaded van, so slabs travel on edge in a proper frame rather than laid flat, and we scout the route before the delivery day.

Unadopted private roads with poor surfaces, no pavements and gravel or shingle drives, plus a rail bridge and narrow lanes on the approach that rule out anything longer than a transit. Even an easy kerbside carry wants the pavement clear at the tail lift, because a three-metre piece on edge has a swing radius nobody expects until it is swinging. Door widths, turn diagonals and any change of level are recorded on the drawing alongside the run dimensions. The template records it along with everything else.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop design & quotation, worktop fabrication and worktop installation. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. The junction between the original room and the extension is the point to watch, because the two floors rarely sit at the same height. No stone is ever cut from a plan, which is inconvenient exactly when a programme is tight. The room as it is, not as it was drawn.

Seating overhangs past roughly 300mm will not carry on the carcass alone, so flat steel bar or a plywood substrate has to be built into the units first. Join positions and vein direction are marked on the template drawing before it leaves site. The drawing leaves site complete. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Where a breast interrupts a long wall the join can often go there, so it reads as a natural break rather than a line in the middle of a worktop. The template plots it as it is, at the exact height the worktop will sit, and the drawing carries that through. Measured at worktop height, nowhere else. All runs and the island carcass fixed down and levelled to one datum, with the sink, tap and hob on site - an island cannot be templated while it is still loose or sitting on packers. The householder is normally on site at template, and that is the right time to settle sink position, tap centres and overhang rather than agree them by email. The template happens when the units are in, fixed and level, whoever is fitting them. Fitted, fixed and level, then we come.