Worktop design and quotation in Chingford Hatch

Yes. Chingford Hatch is on the patch, and the postcodes we work here are E4. It is worked on our east London run, along with the rest of Waltham Forest. A drive that shelves towards the house needs the van chocked and the trolley controlled, since a loaded A-frame gathers speed quickly on a slope. Where a bay suspension or a permit is needed, that is a real cost and it goes on the quote instead of appearing later. It is one line among the others, and it is honest. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Walls look modern and are not: block or breeze with a skim that has been patched over decades, so dry-laying and scribing still apply. With little area to spread them over, the cut-outs and the fixed lines carry the quote, so each is listed on its own. That is what the itemised lines are for. U-shaped post-war kitchens need three pieces with two internal corner joints, and the corner joints want to be mitred rather than butted for a clean line.

Cul-de-sac layouts with wide verges and driveways make parking easy, though some closes are too tight for a long-wheelbase van to turn and need reversing in. Level thresholds and wide rear access are the norm. The side passage is the measurement that matters, because a piece has to be carried flat down it and then turned in at the back door, and the turn is always tighter than the passage. That is why the fitting line on a quote reflects manpower and time rather than square metres. You see that figure before we template, not after.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop templating, worktop installation and worktop replacement. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. The junction between the original room and the extension is the point to watch, because the two floors rarely sit at the same height. Everything is itemised: material, template, fabrication, fitting, each cut-out and each metre of upstand. Nothing payable until we template. Extension kitchens are usually specified long before they are buildable, so the run lengths on the drawing and the run lengths in the room are different numbers. That changes what the quote should be compared against, because the shape of the job is not the same as a single family kitchen. Material is the slab only, and it says so.

The advantage of a U is that every join can be put over a gable in a corner, so nothing lands in the middle of a clear length. Slab yield is worked out at quote stage, so if the layout forces a second slab you hear it before you commit rather than after. No installed rate per square metre, because it is not a real number. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

A junction between an original floor and a later extension slab is almost never at the same level, so units carrying a run across it need packing first. Send photographs of every corner of the room and it gets priced properly first time. Better on the quote than in a variation. Tell us whether there is side or rear access to the kitchen from outside, and send the run lengths with a photo of the window and boiler positions. Owner-occupied kitchens are usually being done once, which is why the edge profile, the vein direction and where a join falls are worth the conversation. Nothing is payable until we template, so a quote can sit while consents and decisions catch up. Nothing payable until template.