Worktop installation in Clapham

Yes. Clapham is on the patch, and the postcodes we work here are SW4. It is worked on our south London run, along with the rest of Lambeth. Permit hours are what matters, not the permit itself, because a bay that frees up at six in the evening is no use for a template at ten. We aim for the first slot of the day where parking is tight, because that is when the street is emptiest. It is why the arrival time is what it is. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

These were built with a scullery that has since been swallowed by an extension, leaving a change of floor level roughly where the run crosses. We measure the front door, the hall width and the turn into the kitchen before anything comes off the van, because a 3m piece has to swing through that corner on edge and stone does not bend to help you. That is the shape of the day. Take the fire doors off before you carry anything up in a converted house here, that 750mm leaf is what stops most jobs, not the stairs.

Permit parking is enforced across the whole area with real pressure near the Common and the High Street. Conversion flats are entered through a shared hallway with a stair that turns twice, and the fire doors on each landing narrow the effective width to well under 800mm. Stone goes up on edge, and it is the half-landing turn rather than the flight itself that sets the maximum piece. Finding it out on the morning costs the whole slot, because there is no second route to fall back on. It gets checked before the first piece is lifted.

It is one of the three we do most here, behind worktop replacement. Same template visit, same workshop, same installers either way. Conversions put kitchens where the services could be made to reach rather than where they belong, so runs are short and interrupted. One visit, with the sink and hob seated and sealed before we leave. Sealed before we leave. In a converted house the flat entrance and the internal doorway are usually tighter than the communal stairs, and that is easy to overlook. The fitting day is scheduled to suit that rather than to suit the diary. One visit, done properly.

The catch with a galley is that both runs are seen end-on from the doorway, so any difference in overhang between the two reads immediately. Joins are pulled with suction clamps and finished flush, then colour-matched, which is the last thing done rather than the first. Dry-lay first, always. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

A junction between an original floor and a later extension slab is almost never at the same level, so units carrying a run across it need packing first. The back edge is eased in progressively rather than offered up once and forced. Dry-lay, mark, cut, then bond. Clear the full hall and stairs route of furniture, bikes, coats and stair-gates, and keep the front door propped and unobstructed for the carry. Mixed ownership means the decision-maker is not always the person who lets us in, so it is worth being clear early about who signs the quote off. A half-day of access is not a fitting day, and it is better to say so at booking than to find out at eleven. Access for the whole slot, or a different day.