Worktop templating in Crews Hill

Yes. Crews Hill is on the patch, and the postcodes we work here are EN2. It is worked on our north London run, along with the rest of Enfield. A front drive is the best thing that can happen to a fitting day, because the tail lift comes down within a few metres of the door and nothing is on a clock. The templating visit needs somewhere to stop for two or three hours, which is a different problem from unloading for twenty minutes. The templater needs a proper stop, not a pause. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

A period cottage has low ceilings, thick rubble-filled walls and a floor that has never been level, and the worktop is the thing that has to look straight. One datum for the whole room, because a floor that falls end to end shows as a step between island and perimeter. Recorded as it is, not as it was drawn. Barn conversions have structural timber posts landing inside the room - the island rarely ends up rectangular, so expect a notched or angled slab rather than a standard shape.

Long unmade or gravel driveways off Cattlegate Road and Crews Hill lanes, gates that need a code, and dogs. The last 100m is often the hardest part of the whole delivery. Communal stairs get boarded and the handrail padded, and we walk the route with a tape before the first piece leaves the van. Door widths, turn diagonals and any change of level are recorded on the drawing alongside the run dimensions. It goes on the drawing with the run dimensions.

It is one of the three we do most here, behind worktop design & quotation. Same template visit, same workshop, same installers either way. Party-wall and lease conditions in a converted building set when noisy work can happen, which shapes the fitting day more than the kitchen does. No stone is ever cut from a plan, which is inconvenient exactly when a programme is tight. The room as it is, not as it was drawn.

Seating overhangs past roughly 300mm will not carry on the carcass alone, so flat steel bar or a plywood substrate has to be built into the units first. A layout templated off one wall instead of one datum will not sit right once all the pieces are down together. One datum for the whole room. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Alcove pieces get cut oversize on both scribe edges, with the true wall angles carried on the template drawing rather than assumed. The template plots it as it is, at the exact height the worktop will sit, and the drawing carries that through. Plotted, not estimated. All runs and the island carcass fixed down and levelled to one datum, with the sink, tap and hob on site - an island cannot be templated while it is still loose or sitting on packers. Where someone is living in the house through the work, the strip-out and the fit are planned so the kitchen is out of use for a day and not a week. The template happens when the units are in, fixed and level, whoever is fitting them. No stone is cut from a plan.