Worktop installation in De Beauvoir Town

Yes. De Beauvoir Town is on the patch, and the postcodes we work here are N1. It is worked on our east London run, along with the rest of Hackney. Enforcement zones rarely accept a trade van unloading stone as an exemption, so this gets sorted before the date is confirmed rather than argued about afterwards. The fitting slot is set around it, which is why we ask about it when the date is booked and not before we leave the yard. We would rather ask than guess. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Listing and conservation conditions apply to a good number of these, which constrains what can be altered around the kitchen rather than what goes on top of the units. We measure the front door, the hall width and the turn into the kitchen before anything comes off the van, because a 3m piece has to swing through that corner on edge and stone does not bend to help you. Walked, measured, protected, then lifted. The houses repeat but the rear extensions do not, each one a different depth and squareness, so template every job rather than reusing a previous set of dimensions from the same street.

A conservation area with permit-only parking and filtered junctions closing most through routes, so the streets are quiet but hard to reach directly. Houses are set back with front paths and steps, and the internal halls are reasonably wide by period standards. Carrying through the house means protecting the whole route first: floor boarded, banister padded, and the front door held open on a wedge rather than by hand. We walk the route with a tape and protect it end to end before the first piece is lifted. It gets checked before the first piece is lifted.

It is one of the three we do most here, behind worktop templating. Same template visit, same workshop, same installers either way. Conversions put kitchens where the services could be made to reach rather than where they belong, so runs are short and interrupted. One visit, with the sink and hob seated and sealed before we leave. The prep list is not optional. Party-wall and lease conditions in a converted building set when noisy work can happen, which shapes the fitting day more than the kitchen does. The fitting day is scheduled to suit that rather than to suit the diary. Sealed before we leave.

An L can be mitred at the corner for a continuous look or butt-jointed over the gable, and the two are different money and different risk. On the day that means dry-laying the whole layout first and only then pulling and bonding the joins. The join is the last thing finished. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Walls that bow along their length are the normal condition rather than the exception, and a straight-cut back edge will show a shadow gap at one end and touch at the other. Rushing that is what leaves a gap you look at every morning for fifteen years. Dry-lay, mark, cut, then bond. Clear the full hall and stairs route of furniture, bikes, coats and stair-gates, and keep the front door propped and unobstructed for the carry. The same building type can arrive as a careful one-off kitchen or as a fast turnaround, and the honest answer is that they are priced differently. A half-day of access is not a fitting day, and it is better to say so at booking than to find out at eleven. Protection goes down first.