Worktop installation in Haggerston

Yes. Haggerston is on the patch, and the postcodes we work here are E2, E8. It is worked on our east London run, along with the rest of Hackney. On a street with no restrictions the constraint is other residents rather than a warden, so it is worth putting a cone or a car out early. A van that has to move mid-fit costs the best part of an hour and takes a man off the tools to do it. The day is built around that window. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

The flat entrance door and the internal doorways are usually tighter than the communal stairs, which is the opposite of what most people assume. We measure the front door, the hall width and the turn into the kitchen before anything comes off the van, because a 3m piece has to swing through that corner on edge and stone does not bend to help you. The slow parts are slow for a reason. The viaduct breaks the street grid so a neighbouring postcode can be a ten-minute drive around, and that needs building into the fit-day schedule rather than discovered at the wheel.

Canal-side developments have controlled entrances and service lifts, while the older estates are courtyard access and stair cores. Several roads are filtered and the railway viaduct decides which streets actually connect to each other. Where the lift will not take the longest run we design a join in rather than gamble, because a piece that will not go up has to go back on the van. We walk the route with a tape and protect it end to end before the first piece is lifted. That is what the morning is planned around.

It is one of the three we do most here, behind worktop replacement. Same template visit, same workshop, same installers either way. A new extension slab is not automatically level, and that wants checking before templating rather than after the stone is cut. The fitting day is scheduled to suit that rather than to suit the diary. The prep list is not optional. The junction between the original room and the extension is the point to watch, because the two floors rarely sit at the same height. Where the window is fixed there is no second day to fall back on, so the prep list matters more than usual. Sealed before we leave.

Because a peninsula is seen from both sides, the underside of any overhang gets the same edge treatment as the top, which is easy to leave out of a spec. A layout that has been packed and levelled run by run instead of to one datum shows as a step where two pieces meet. The join is the last thing finished. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Where a corner is a couple of degrees off, a mitre cut to a theoretical ninety degrees opens on the wall side and there is no closing it afterwards. The back edge is eased in progressively rather than offered up once and forced. Dry-lay, mark, cut, then bond. Clear the full hall and stairs route of furniture, bikes, coats and stair-gates, and keep the front door propped and unobstructed for the carry. Managed stock usually comes with its own rules about working hours, waste, and who is allowed on site. Floors and units are protected before anything comes through the door, communal or otherwise. Access for the whole slot, or a different day.