Kitchen worktops in Haggerston

Yes. Post-war estate flats with fixed galley kitchens, canal-side new builds with open-plan runs and peninsulas, and a thinner layer of Victorian terraces with rear additions. Extension work is limited because the stock is so flat-dominated. A free-parking street with cars both sides can still leave the van forty metres away, and that distance is carry, not driving. The fitting slot is set around it, which is why we ask about it when the date is booked and not before we leave the yard. It is why the arrival time is what it is.

Victorian terrace, post-war estate block, canal-side new build and warehouse conversion. Lease conditions and the other flats in the building decide when noisy work can happen, so the fitting day has a start and a finish that are not ours to set. In most Victorian terraces the kitchen sits in the back addition, so you get a narrow galley with one outside wall and nothing square to work off. Units kept, surface changed, one day.

Canal-side developments have controlled entrances and service lifts, while the older estates are courtyard access and stair cores. Several roads are filtered and the railway viaduct decides which streets actually connect to each other. The lift has to be booked and blanketed before anything moves, and that booking needs to cover the old tops coming out as well as the new stone going in. Worth remembering that the old tops have to come out the way the new ones come in, and a laminate run is easier to remove in one length than to carry in one. The strip-out is planned around it.

Worktop replacement, worktop installation and worktop splashbacks & upstands, in that order. The junction between the original room and the extension is the point to watch, because the two floors rarely sit at the same height. Splashbacks and upstands are cut from the same slab run at the same time, which is the only way the batch actually matches. Sockets final before template. The viaduct breaks the street grid so a neighbouring postcode can be a ten-minute drive around, and that needs building into the fit-day schedule rather than discovered at the wheel.

Because a peninsula is seen from both sides, the underside of any overhang gets the same edge treatment as the top, which is easy to leave out of a spec. A layout that has been packed and levelled run by run instead of to one datum shows as a step where two pieces meet. Dry-lay first, always. Where a corner is a couple of degrees off, a mitre cut to a theoretical ninety degrees opens on the wall side and there is no closing it afterwards. It is usually what pushes a job towards a 100mm upstand instead of a full-height panel, because an upstand rides what a panel exposes. Make the wall good first, or accept the detail. Material runs from £110 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines rather than rolled into one figure.

Where a landlord or housing provider is involved there is a specification to meet and a process to follow, and both are settled before a date is offered. A 100mm upstand is the low-maintenance answer, and full-height stone is the one that has to be committed to early. Decided before fabrication, not after. Tell us the building when you book and the lift, the stair turn and any freeholder notice get built into the day rather than found on it.