Kitchen worktops in Dalston

Yes. Above-shop flats along the main roads with tiny internal kitchens, Victorian terraces split into flats behind them, and newer towers with open-plan kitchens. The commonest job by far is a 2.4-3m replacement run in a converted flat where nothing structural can be moved. The realistic answer on a main road is an early slot, a spotter on the van and pieces staged in one movement rather than several trips. Splashbacks are normally the last thing off, so a short parking window is exactly when they get rushed. Handling is where these pieces get damaged.

Victorian terrace, above-shop flat, post-war estate and new-build tower. A villa cut into flats leaves kitchens in rooms that were never kitchens, with services run to wherever they could physically be made to reach. Where a client wants a full-height piece behind the hob, it usually sits in the old chimney recess, and that recess is rarely square top to bottom or side to side, so it has to be templated as a trapezium rather than a rectangle. Cut from the same slab run as the tops.

Kingsland High Street is on the A10 red route so nothing stops on it, and loading has to go to side streets that are permit-only and frequently filtered. Above-shop flats have a narrow street door beside the shopfront and a steep straight stair with a turn at the top. A walk-up with winders at every half-landing means the piece is rested and re-gripped on the way, so the crew size goes up before the piece size comes down. Splashback panels are lighter than a worktop and far more awkward, because a tall thin piece has to be carried on edge and cannot be tilted to clear a turn. Joint positions follow from that.

Worktop replacement, worktop splashbacks & upstands and worktop installation, in that order. Party-wall and lease conditions in a converted building set when noisy work can happen, which shapes the fitting day more than the kitchen does. The fitting day is scheduled to suit that rather than to suit the diary. One visit, done properly. Above-shop stairs plus a right angle at the landing usually force a two-piece top on a 3m run, so quote the join up front instead of discovering it on the day.

Galley runs are usually short enough to come out of a single slab, so the material band you choose does more to the total than the room shape does. The same shape decides where splashback pieces break, and a joint in a corner reads as a detail while one in a clear run reads as a mistake. Joint placement is a decision, not an accident. Walls that bow along their length are the normal condition rather than the exception, and a straight-cut back edge will show a shadow gap at one end and touch at the other. On the day it means dry-laying, marking, and cutting the scribe on site before anything is bonded. Dry-lay, mark, cut, then bond. Material runs from £110 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines rather than rolled into one figure.

The same building type can arrive as a careful one-off kitchen or as a fast turnaround, and the honest answer is that they are priced differently. The fitting day is arranged with whoever can actually give us access for the whole slot. Access for the whole slot, or a different day. Tell us the building when you book and the lift, the stair turn and any freeholder notice get built into the day rather than found on it.