Kitchen worktops in London Fields

Yes. Victorian terraces facing the park, many reverted to whole houses, where a side-return or rear extension creates a kitchen-diner with a 4m run and an island. Behind the market the converted industrial buildings give large open-plan kitchens with long single runs and few obstructions. The practical answer is to check the fixture list before the date is offered, because a template slot lost to a road closure cannot be recovered that week. A templater circling for a space arrives late into a slot that was already tight, and the drawing is what suffers. It goes on the job sheet for the fitting crew.

Victorian terrace, warehouse conversion, above-shop flat and post-war infill. These were built with a scullery that has since been swallowed by an extension, leaving a change of floor level roughly where the run crosses. Victorian party walls and chimney-breast returns bow along their length, so the template plots the real line rather than assuming a straight one - the template picks up points every few hundred millimetres down the back of the run and the drawing carries that curve through to the saw. Two to three hours, once the units are in.

The streets around the park are permit-only, filtered and busy with pedestrians and cyclists, and market days make the Broadway Market end effectively impassable for a van. Extension jobs usually allow a carry through the house or via a side gate straight into the rear. Garden routes carry their own hazards: a drain cover, a step up to a patio, wet decking, or a lawn that will not take a loaded trolley. The templater measures that route on the same visit, so the drawing leaves site already knowing the maximum piece. The template records it along with everything else.

Worktop templating, worktop installation and worktop design & quotation, in that order. A new extension slab is not automatically level, and that wants checking before templating rather than after the stone is cut. The template visit is booked once the units are genuinely in, not when they are nearly in. The room as it is, not as it was drawn. On extension jobs check for a side gate first, because going in through the garden avoids the hall and the stair entirely and makes a one-piece island top possible.

Two parallel runs with a walkway between them is the most efficient shape there is on a slab, because both pieces nest as straight lengths with almost no waste. Each run is priced on its own line against the supply rate, with the join count and the reason for each join stated. The join count is stated with its reason. Where a corner is a couple of degrees off, a mitre cut to a theoretical ninety degrees opens on the wall side and there is no closing it afterwards. On the day it means dry-laying, marking, and cutting the scribe on site before anything is bonded. Eased in, never forced. Material runs from £110 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines rather than rolled into one figure.

Mixed ownership means the decision-maker is not always the person who lets us in, so it is worth being clear early about who signs the quote off. The template happens when the units are in, fixed and level, whoever is fitting them. Fitted, fixed and level, then we come. Tell us the building when you book and the lift, the stair turn and any freeholder notice get built into the day rather than found on it.