Kitchen worktops in Hackney Central

Yes. A mix of terraces converted to flats, estate blocks and recent apartments above the town centre, so older stock gives rear-addition kitchens of about 3m while new blocks are open-plan with a 3m run and a peninsula. The Georgian survivors near the churchyard have small original rooms with layouts that cannot be moved. Where the bay sits some distance from the core, the carry across the car park is the longest leg of the day and gets boarded and lit. The templating visit needs somewhere to stop for two or three hours, which is a different problem from unloading for twenty minutes. It goes on the job sheet for the fitting crew.

Victorian terrace, Georgian survivor, post-war estate and new-build apartment. Cornice, picture rails and deep skirting survive in converted rooms, so the run stands off the wall and the back edge follows the units rather than the plaster. We measure the front door, the hall width and the turn into the kitchen before anything comes off the van, because a 3m piece has to swing through that corner on edge and stone does not bend to help you. That is the shape of the day.

Mare Street has bus lanes and loading restrictions, and the surrounding grid is filtered with several streets closed to through traffic by camera-enforced gates. New blocks have service lifts and booked bays, while the older terraces mean a shared hall and a first-floor turn. Where the lift will not take the longest run we design a join in rather than gamble, because a piece that will not go up has to go back on the van. The fitting day is planned backwards from that point, before anything comes off the van. That is what the morning is planned around.

Worktop replacement, worktop installation and worktop templating, in that order. A kitchen carved out of a larger room sits under whatever the original plan left behind, so the run frequently ends at a blocked doorway or a boxed-in service. The template visit is booked once the units are genuinely in, not when they are nearly in. Units fitted, fixed and level first. Camera-enforced filters catch more fitters here than anything else, so drive the van route on the ground beforehand and build the longer legal approach into the day.

Peninsulas frequently land on a lightweight partition or on units that were never fixed down, and stone needs proper support under it before it goes on. On the day that means dry-laying the whole layout first and only then pulling and bonding the joins. Dry-lay first, always. Where a corner is a couple of degrees off, a mitre cut to a theoretical ninety degrees opens on the wall side and there is no closing it afterwards. On the day it means dry-laying, marking, and cutting the scribe on site before anything is bonded. Dry-lay, mark, cut, then bond. Material runs from £110 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines rather than rolled into one figure.

A street with houses in single occupation next to the same houses cut into flats produces two completely different jobs from the same elevation. The template happens when the units are in, fixed and level, whoever is fitting them. No stone is cut from a plan. Tell us the building when you book and the lift, the stair turn and any freeholder notice get built into the day rather than found on it.