Kitchen worktops in Shacklewell

Yes. Narrow Victorian terraces largely in flats with rear-addition kitchens of 2.8-3m, plus estate flats with fixed galleys. A handful of converted industrial buildings on the fringes provide the only open-plan runs in the area. The realistic answer on a main road is an early slot, a spotter on the van and pieces staged in one movement rather than several trips. A replacement is a two-way job, with old tops going out and new stone coming in, so the van needs to stay put across the whole day. Old tops out and new stone in, both through the same gap.

Victorian terrace, post-war estate, above-shop flat and warehouse conversion. The addition wall is half a brick thick in places and has usually had a damp course injected and been re-plastered, which leaves it neither flat nor consistent. In most Victorian terraces the kitchen sits in the back addition, so you get a narrow galley with one outside wall and nothing square to work off. What is under the old top is the real question.

Boxed in by the A10 red route on one side and filtered residential streets on the other, so the legal approach is usually a loop rather than a straight line. Terrace front doors open onto a narrow hall with the stair starting almost immediately, which limits the swing. Communal stairs get boarded and the handrail padded, and we walk the route with a tape before the first piece leaves the van. Worth remembering that the old tops have to come out the way the new ones come in, and a laminate run is easier to remove in one length than to carry in one. The strip-out is planned around it.

Worktop replacement, worktop installation and worktop splashbacks & upstands, in that order. Extension kitchens are usually specified long before they are buildable, so the run lengths on the drawing and the run lengths in the room are different numbers. The units stay and only the surface changes, so the whole job is one day rather than a kitchen refit. A day, not a project. When the stair starts within a metre of the front door there is no room to pivot, so pieces have to be short enough to turn on the spot rather than swung round the newel.

The catch with a galley is that both runs are seen end-on from the doorway, so any difference in overhang between the two reads immediately. A layout that has been packed and levelled run by run instead of to one datum shows as a step where two pieces meet. Dry-lay first, always. Boxing is rarely the same depth at worktop height as it is at floor level, so measuring it low down is the usual reason a top will not sit back. Rushing that is what leaves a gap you look at every morning for fifteen years. Dry-lay, mark, cut, then bond. Material runs from £110 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines rather than rolled into one figure.

Managed stock usually comes with its own rules about working hours, waste, and who is allowed on site. A 100mm upstand is the low-maintenance answer, and full-height stone is the one that has to be committed to early. Same slab run as the tops. Tell us the building when you book and the lift, the stair turn and any freeholder notice get built into the day rather than found on it.