Kitchen worktops in Hoxton

Yes. Georgian houses around the squares with small compartmented rooms, large post-war estates with standard galley kitchens, and a few converted industrial buildings with open-plan runs. Most of the work is replacement within the existing footprint rather than reconfiguration. Where the frontage is a clearway the unload happens away from the door and the carry gets longer, which is a crew and time question rather than a stone one. A replacement is a two-way job, with old tops going out and new stone coming in, so the van needs to stay put across the whole day. Old tops out and new stone in, both through the same gap.

Georgian terrace, Victorian terrace, large post-war estate and warehouse conversion. These are built in dense concrete, so support for a peninsula or an end panel goes in with proper anchors rather than plugs. The carry is the constraint. That is the shape of the day.

Estate courtyards with bollards, filtered residential streets, red route sections on the A10 edge and restrictions on Old Street to the south. Estate blocks have small lifts and long deck-access walkways to cross before you reach the door. The barrier, the entry code and the estate rules decide when a van can get near the door, and none of that is negotiable on the day. The fitting day is planned backwards from that point, before anything comes off the van. It gets checked before the first piece is lifted.

Worktop replacement, worktop installation and worktop splashbacks & upstands, in that order. The junction between the original room and the extension is the point to watch, because the two floors rarely sit at the same height. Splashbacks and upstands are cut from the same slab run at the same time, which is the only way the batch actually matches. Sockets final before template. Deck-access blocks mean a long exposed carry along an open walkway, so weather matters here in a way it does not elsewhere, and a slab on edge in a gust four floors up is the risk to design out.

A galley puts the sink on one side and the hob on the other, which spreads the cut-outs across two pieces instead of weakening one. A layout that has been packed and levelled run by run instead of to one datum shows as a step where two pieces meet. Dry-lay first, always. A boxed soil stack or service riser in the corner of a run eats into the worktop depth and has to be scribed around rather than cut square. It is usually what pushes a job towards a 100mm upstand instead of a full-height panel, because an upstand rides what a panel exposes. An upstand rides what a panel exposes. Material runs from £110 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines rather than rolled into one figure.

Mixed ownership means the decision-maker is not always the person who lets us in, so it is worth being clear early about who signs the quote off. The fitting day is arranged with whoever can actually give us access for the whole slot. Protection goes down first. Tell us the building when you book and the lift, the stair turn and any freeholder notice get built into the day rather than found on it.