Splashbacks and upstands in Denmark Hill

Yes. Denmark Hill is on the patch, and the postcodes we work here are SE5. It is worked on our south east London run, along with the rest of Southwark. Off-street parking means the van stays put all day, so tools, packers and the offcut we would rather have than not are all within reach. Panels come off the van in one trip where possible, since a tall piece handled repeatedly is a piece asking to be chipped. One trip is always better than three. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Handmade brick and lime plaster move visibly along a run, and a straight-cut back edge shows it immediately. Behind a range cooker with gas burners, granite or sintered stone is the sensible pick; quartz has a resin binder and does not enjoy sustained radiant heat at close range, so keep it out of the immediate hob zone or specify a different material for that panel. Cut from the same slab run as the tops. Big rooms tempt clients into a single long piece, but the villa hallways will not take it - plan a joint at the hob or sink and make it invisible.

A steep hill with parking bays on a slope, hospital traffic all day, and mansion blocks with a shared entrance hall and a half-turn stair; villa driveways are short and often shared. Stone goes up on edge, and it is the half-landing turn rather than the flight itself that sets the maximum piece. Where the route is tight we break a long splashback at a natural vertical joint instead of forcing one panel through. It decides panel size before anything is cut.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop design & quotation, worktop templating and worktop installation. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. The junction between the original room and the extension is the point to watch, because the two floors rarely sit at the same height. Ordered later from a different batch, the match is not reliable exactly where the pieces meet. Same batch, same run, same day. Rear and side-return extensions are where the islands appear, and an island is the piece that decides whether one slab does the kitchen or two. Splashbacks and upstands are cut from the same slab run at the same time, which is the only way the batch actually matches. Sockets final before template.

Seating overhangs past roughly 300mm will not carry on the carcass alone, so flat steel bar or a plywood substrate has to be built into the units first. The same shape decides where splashback pieces break, and a joint in a corner reads as a detail while one in a clear run reads as a mistake. Corners get their own pieces. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

The returns into a breast recess are the tightest scribes in the room, and they are eased in rather than forced. Where the wall cannot be made good, setting the stone deliberately proud on a subframe with a shadow gap reads as a detail rather than a bad fit. Scribed, dubbed out, or set proud. Pick one. The range and extractor must be sited and the window cill finished before the template, as both fix the vertical limits of the splashback. An owner living in the house makes the decisions and lives with them, so the specification tends to go towards the material rather than towards the lowest total. Splashbacks are cut from the same slab run as the tops, so they have to be decided before fabrication, not after. Decided before fabrication, not after.