Worktop installation in Denmark Hill

Yes. Denmark Hill is on the patch, and the postcodes we work here are SE5. It is worked on our south east London run, along with the rest of Southwark. Gravel and block paving both look like hard standing and neither takes a loaded trolley, so the run from tail lift to door gets boarded. The fitting slot is set around it, which is why we ask about it when the date is booked and not before we leave the yard. It is why the arrival time is what it is. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Original joinery is deep and stands proud of the plaster, so the run is plotted to the units rather than to the wall behind them. Access through the property is usually the simplest of any archetype, with wide doors and generous rooms, so we can often carry a full-length piece straight in without a planned join. That is the shape of the day. Big rooms tempt clients into a single long piece, but the villa hallways will not take it - plan a joint at the hob or sink and make it invisible.

A steep hill with parking bays on a slope, hospital traffic all day, and mansion blocks with a shared entrance hall and a half-turn stair; villa driveways are short and often shared. Communal stairs get boarded and the handrail padded, and we walk the route with a tape before the first piece leaves the van. We walk the route with a tape and protect it end to end before the first piece is lifted. That is what the morning is planned around.

It is one of the three we do most here, behind worktop design & quotation. Same template visit, same workshop, same installers either way. Rear and side-return extensions are where the islands appear, and an island is the piece that decides whether one slab does the kitchen or two. The fitting day is scheduled to suit that rather than to suit the diary. The prep list is not optional. The junction between the original room and the extension is the point to watch, because the two floors rarely sit at the same height. Where the window is fixed there is no second day to fall back on, so the prep list matters more than usual. Sealed before we leave.

Seating overhangs past roughly 300mm will not carry on the carcass alone, so flat steel bar or a plywood substrate has to be built into the units first. A layout that has been packed and levelled run by run instead of to one datum shows as a step where two pieces meet. Dry-lay first, always. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

A chimney breast left in place splits a wall into two alcoves, and the two are rarely the same width and rarely parallel to each other. Rushing that is what leaves a gap you look at every morning for fifteen years. It is the slow part of the day and it should be. Give us the hardest, shortest approach to the door you can, clear of parked cars, and warn us of any soft ground, steps or gravel on the route. The householder is normally on site at template, and that is the right time to settle sink position, tap centres and overhang rather than agree them by email. Floors and units are protected before anything comes through the door, communal or otherwise. Protection goes down first.