Kitchen worktops in Dollis Hill

Yes. Interwar semis stepping up the hill, with the original kitchen and larder at the back and a strong pattern of single-storey rear extensions built to catch the garden light. Typical finished kitchen is an L of roughly 3.6m plus 2m with a small breakfast peninsula, and the utility usually ends up in a converted garage or a lean-to. Gravel and block paving both look like hard standing and neither takes a loaded trolley, so the run from tail lift to door gets boarded. The templating visit needs somewhere to stop for two or three hours, which is a different problem from unloading for twenty minutes. The templater needs a proper stop, not a pause.

1920s-30s semi, 1930s terrace and post-war low-rise flat. These kitchens have been retiled at least twice, and stripping the tiles takes the bottom band of plaster with them because the old laminate ran underneath rather than up to them. Access is usually the easy part here, as most of these have a side gate and a back door straight into the kitchen, so we carry down the side alley rather than through the house and keep the mess outside. That is the shape of the day.

Genuinely hilly streets around Gladstone Park with sloped driveways, so a barrow is worse than a straight carry and the van needs chocking. Dropped kerbs are common, which is the main advantage over the terraced areas below. Rear access usually lets us fit longer pieces whole, so the join count ends up decided by the slab rather than by the building. Finding it out on the morning costs the whole slot, because there is no second route to fall back on. That is what the morning is planned around.

Worktop installation, worktop replacement and worktop templating, in that order. A new extension slab is not automatically level, and that wants checking before templating rather than after the stone is cut. No stone is ever cut from a plan, which is inconvenient exactly when a programme is tight. Units fitted, fixed and level first. Sloped drives and steps up to the side gate make the walk-in the risk, not the kitchen, so two extra pairs of hands beat a clever route.

An L can be mitred at the corner for a continuous look or butt-jointed over the gable, and the two are different money and different risk. The existing layout is being kept, so the question is whether the old carcasses will take stone in that shape without more support. Carcasses have to be sound first. A run can measure dead right at both ends and still belly out in the middle, which only appears once the template plots the intermediate points. Rushing that is what leaves a gap you look at every morning for fifteen years. Dry-lay, mark, cut, then bond. Material runs from £110 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines rather than rolled into one figure.

An owner living in the house makes the decisions and lives with them, so the specification tends to go towards the material rather than towards the lowest total. The template happens when the units are in, fixed and level, whoever is fitting them. No stone is cut from a plan. Tell us the building when you book and the lift, the stair turn and any freeholder notice get built into the day rather than found on it.