Worktop replacement in Earlsfield

Yes. Earlsfield is on the patch, and the postcodes we work here are SW18. It is worked on our south west London run, along with the rest of Wandsworth. A controlled parking zone means either a visitor permit sorted in advance or a suspended bay, and a suspension is applied for days ahead rather than on the morning. Waste is the part people forget: the old laminate or tired granite has to be walked back to the van and it does not get lighter. The waste run is planned, not improvised. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Cornice, picture rails and deep skirting survive in converted rooms, so the run stands off the wall and the back edge follows the units rather than the plaster. What the old top has been hiding is usually a floor that settled towards the back and units that were never fixed back to the wall. Units kept, surface changed, one day. Side-return roofs here often bring a downpipe or a boiler flue through the new flank wall, so the run gets a notch or a shortened piece that has to be picked up at template, not at fit.

Streets are permit-controlled with narrow carriageways, and the railway embankment and Garratt Lane traffic limit approach routes. Front gardens are shallow, so there is barely a metre to stage a slab before the door. Carrying through the house means protecting the whole route first: floor boarded, banister padded, and the front door held open on a wedge rather than by hand. Worth remembering that the old tops have to come out the way the new ones come in, and a laminate run is easier to remove in one length than to carry in one. The strip-out is planned around it.

It is one of the three we do most here, behind worktop templating. Same template visit, same workshop, same installers either way. Small kitchens in a shared house are all short runs and tight cut-out spacing, which is more bench work per square metre than one large kitchen would be. The units stay and only the surface changes, so the whole job is one day rather than a kitchen refit. A day, not a project. Batching several kitchens together is the one situation where buying a whole slab is cheaper per kitchen rather than more expensive. Old tops out in the morning, new stone down and sealed the same afternoon. A day, not a project.

A galley run down a side-return extension usually measures longer than a slab will give in one length, so a join is designed in from the start rather than discovered. Going from a 38mm laminate to 20mm or 30mm stone drops the surface, which shows against tiles, a window board and any freestanding appliance. Height change is checked before we cut. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Anything that has to stay accessible, a stopcock, a gas meter, a riser panel, is marked on the template so the stone is cut around it instead of over it. This is the commonest reason a replacement turns out to need more than a straight swap. Found at template, not on fit day. Have a plumber booked to disconnect the sink, tap and waste first thing and reconnect after we have gone, and clear the hallway and stairs completely so we can carry slabs through the house. Where ownership is split across a building, the common parts belong to someone else and the carry route is negotiated rather than assumed. A replacement keeps the units and changes the surface, which is the least disruptive way to do this in an occupied property. Units kept, surface changed.