Worktop replacement in Wandsworth Common

Yes. Wandsworth Common is on the patch, and the postcodes we work here are SW18, SW11, SW12. It is worked on our south west London run, along with the rest of Wandsworth. Permit hours are what matters, not the permit itself, because a bay that frees up at six in the evening is no use for a template at ten. We stage the strip-out so the old tops leave in one trip rather than trickling out across the afternoon. The waste run is planned, not improvised. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Rooms are tall with deep window reveals, and a run finishing into a reveal is templated to it rather than assumed square. What the old top has been hiding is usually a floor that settled towards the back and units that were never fixed back to the wall. Units kept, surface changed, one day. Getting stone down a lightwell stair is the constraint here, not the room, measure the stair headroom and the turn radius before agreeing any single-piece island top.

Many of these houses have a lower-ground entrance via a front lightwell with a steep flight of steps and a tight turn at the bottom, the worst carry in the area. On-street parking is permit-controlled with limited visitor bays. Communal stairs get boarded and the handrail padded, and we walk the route with a tape before the first piece leaves the van. Worth remembering that the old tops have to come out the way the new ones come in, and a laminate run is easier to remove in one length than to carry in one. The strip-out is planned around it.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop design & quotation, worktop templating and worktop fabrication. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. A second kitchen or a kitchenette in an annexe is a small job with the same fixed template, fabrication and fitting lines as a large one. The units stay and only the surface changes, so the whole job is one day rather than a kitchen refit. Sound carcasses or it does not go ahead. Where an annexe has been built or converted, its floor and its walls are newer than the main house and behave differently under the same run. Old tops out in the morning, new stone down and sealed the same afternoon. A day, not a project.

Seating overhangs past roughly 300mm will not carry on the carcass alone, so flat steel bar or a plywood substrate has to be built into the units first. The existing layout is being kept, so the question is whether the old carcasses will take stone in that shape without more support. Carcasses have to be sound first. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Where a corner is a couple of degrees off, a mitre cut to a theoretical ninety degrees opens on the wall side and there is no closing it afterwards. This is the commonest reason a replacement turns out to need more than a straight swap. The laminate has been covering it up. Have a plumber booked to disconnect the sink, tap and waste first thing and reconnect after we have gone, and clear the hallway and stairs completely so we can carry slabs through the house. A street with houses in single occupation next to the same houses cut into flats produces two completely different jobs from the same elevation. If the carcasses are tired the honest answer is that stone will find that out, and it is better said before than after. Units kept, surface changed.