Kitchen worktops in Erith

Yes. A riverside town with a lot of flats, tower and low-rise estate kitchens are single-run 2.4m boxes, newer riverside apartments have open-plan runs with an island, and the surviving Victorian terraces on the hill have small rear-addition kitchens. Underground loading has a height restriction, and a van with an A-frame on it is taller than the driver remembers. Waste is the part people forget: the old laminate or tired granite has to be walked back to the van and it does not get lighter. The waste run is planned, not improvised.

Victorian terrace, 1960s tower block, postwar estate and 2000s-2010s riverside apartment. Entry-phone access, a booked lift and a parking bay near the entrance all have to be arranged before a date is confirmed. The plaster is bonded straight onto the concrete, so the bottom course of tiles tends to bring plaster with it when the old top comes off, leaving a rough band behind the upstand. Sound carcasses are the one condition.

Tower blocks with small passenger lifts and long internal corridors, riverside blocks with a loading bay, and a steep climb up from the riverside that makes any carry harder than it looks on a map. The lift has to be booked and blanketed before anything moves, and that booking needs to cover the old tops coming out as well as the new stone going in. With no room to turn, the old top gets cut up in the kitchen instead, which is dusty work and needs the room emptied first. The strip-out is planned around it.

Worktop replacement, worktop fabrication and worktop templating, in that order. Extension kitchens are usually specified long before they are buildable, so the run lengths on the drawing and the run lengths in the room are different numbers. So the nesting is planned around it rather than around a standard kitchen. Same slab run, or it is not a match. Lift dimensions in the older towers are the hard limit here, most runs go in as two or three jointed pieces.

If the island is a few hundred millimetres longer than the usable length of a slab, a second slab gets bought to gain that overhang, and the whole slab is paid for rather than the part used. The existing layout is being kept, so the question is whether the old carcasses will take stone in that shape without more support. Carcasses have to be sound first. A notch around a boxed stack is machined with a radius at the internal corner, because a square inside corner there is exactly where a top will crack. One measurement never describes it, which is why a tape reading taken before the visit rarely matches the template. Plotted, not estimated. Material runs from £110 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines rather than rolled into one figure.

Where ownership is split across a building, the common parts belong to someone else and the carry route is negotiated rather than assumed. Changing an appliance after the nest is set means recutting the piece, not adjusting it. The approved drawing is the instruction. Tell us the building when you book and the lift, the stair turn and any freeholder notice get built into the day rather than found on it.