Worktop design and quotation in Falconwood

Yes. Falconwood is on the patch, and the postcodes we work here are DA16, SE9. It is worked on our south east London run, along with the rest of Bexley. Off-street parking means the van stays put all day, so tools, packers and the offcut we would rather have than not are all within reach. It sits in the fitting line as time on site rather than as anything to do with the stone. It is one line among the others, and it is honest. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

These kitchens have been retiled at least twice, and stripping the tiles takes the bottom band of plaster with them because the old laminate ran underneath rather than up to them. These are typically two runs and a return, often into a rear extension, and the return piece is the awkward one, short, wide and rarely nesting well against the long pieces on the slab, so slab yield rather than total area is what pushes the material line up. That is what the itemised lines are for. The original attached garages give something rare round here, a level, covered spot to set up and cut on site.

Wide crescents and cul-de-sacs with garages and drives on almost every plot; the railway and the main road cutting across the area limit through routes more than parking does. Rear access usually lets us fit longer pieces whole, so the join count ends up decided by the slab rather than by the building. An access-driven join is priced like any other join, and people are always surprised to see one on a dead straight run. It appears as its own line rather than buried in a rate.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop installation, worktop replacement and worktop templating. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. The junction between the original room and the extension is the point to watch, because the two floors rarely sit at the same height. That changes what the quote should be compared against, because the shape of the job is not the same as a single family kitchen. Itemised, so it can be compared honestly. Extension kitchens are usually specified long before they are buildable, so the run lengths on the drawing and the run lengths in the room are different numbers. Comparing quotes only works when they itemise the same things, and this is where the differences usually hide. Material is the slab only, and it says so.

Where the return runs into a wall that is out of square, the corner is templated as the angle it really is rather than as ninety degrees. Each run is priced on its own line against the supply rate, with the join count and the reason for each join stated. Shape first, area second. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Where a breast interrupts a long wall the join can often go there, so it reads as a natural break rather than a line in the middle of a worktop. This is the item most often left out of a cheaper quote, and it comes back as a variation once the templater has been. Better on the quote than in a variation. Send the extension drawing or the unit layout with the actual appliance model numbers, since cut-out sizes come from the appliance, not the cabinet. An owner living in the house makes the decisions and lives with them, so the specification tends to go towards the material rather than towards the lowest total. The quote is written so it can be read by whoever is paying rather than only by whoever is standing in the kitchen. Every line has a reason next to it.