Kitchen worktops in Falconwood

Yes. A planned interwar estate of near-identical semis backing onto woodland, so kitchen layouts repeat: rear kitchen with a garage or side passage on one side, most now opened into the dining room for a 3.2m to 3.6m L. Gravel and block paving both look like hard standing and neither takes a loaded trolley, so the run from tail lift to door gets boarded. Waste is the part people forget: the old laminate or tired granite has to be walked back to the van and it does not get lighter. The waste run is planned, not improvised.

1930s speculative semi, interwar detached and postwar infill. The classic arrangement is the original back room with a later extension bolted onto it, so the kitchen is two ages of building in one room. The fitting itself is slower than the carry: original plaster on the party wall and around the old chimney breast is rarely square to the run, so back scribes get cut on site, and where a return wraps into a breast recess we template that shoulder tight and ease it in. That is the shape of the day.

Wide crescents and cul-de-sacs with garages and drives on almost every plot; the railway and the main road cutting across the area limit through routes more than parking does. Garden routes carry their own hazards: a drain cover, a step up to a patio, wet decking, or a lawn that will not take a loaded trolley. Finding it out on the morning costs the whole slot, because there is no second route to fall back on. That is what the morning is planned around.

Worktop installation, worktop replacement and worktop templating, in that order. Extension kitchens are usually specified long before they are buildable, so the run lengths on the drawing and the run lengths in the room are different numbers. The units stay and only the surface changes, so the whole job is one day rather than a kitchen refit. A day, not a project. The original attached garages give something rare round here, a level, covered spot to set up and cut on site.

An L can be mitred at the corner for a continuous look or butt-jointed over the gable, and the two are different money and different risk. On the day that means dry-laying the whole layout first and only then pulling and bonding the joins. Dry-lay first, always. Where a breast interrupts a long wall the join can often go there, so it reads as a natural break rather than a line in the middle of a worktop. On the day it means dry-laying, marking, and cutting the scribe on site before anything is bonded. Dry-lay, mark, cut, then bond. Material runs from £110 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines rather than rolled into one figure.

Where someone is living in the house through the work, the strip-out and the fit are planned so the kitchen is out of use for a day and not a week. A replacement keeps the units and changes the surface, which is the least disruptive way to do this in an occupied property. Units kept, surface changed. Tell us the building when you book and the lift, the stair turn and any freeholder notice get built into the day rather than found on it.