Worktop fabrication in Farnborough

Yes. Farnborough is on the patch, and the postcodes we work here are BR6. It is worked on our south east London run, along with the rest of Bromley. A front drive is the best thing that can happen to a fitting day, because the tail lift comes down within a few metres of the door and nothing is on a clock. It rarely changes what we cut, but it does change how the pieces are stacked and strapped for the run out. The load plan follows from it. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

A range or an Aga in an original recess is usually immovable, so the run is designed around it and the clearances come from the appliance. Access is off a drive and through wide doors, so for once the piece size is not the constraint - the joins that go in are the ones we choose for layout and veining, not the ones the building forces. Settled on the drawing, cut once. In the old cottages nothing is level or plumb, so we scribe against the walls and expect to take 15mm out of a template edge on site.

The village high street is narrow with no loading room and traffic behind you, so unloading has to be quick and often at an angle; the surrounding closes are far easier with drives. A short hard approach with no steps means a full-length piece can be walked in flat by two people rather than turned up on edge. So the nesting is worked to the measured route first and to the slab second. It is settled on the bench, not on site.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop templating, worktop installation and worktop replacement. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. A new extension slab is not automatically level, and that wants checking before templating rather than after the stone is cut. So the nesting is planned around it rather than around a standard kitchen. Proven on the bench before dispatch. The junction between the original room and the extension is the point to watch, because the two floors rarely sit at the same height. Cutting several kitchens from different slabs and calling them matched is where firms get caught out. Nested for the job in front of us.

Galley runs are usually short enough to come out of a single slab, so the material band you choose does more to the total than the room shape does. The nest is laid out around that, with joins placed over cabinet gables and kept clear of every cut-out. That is nested before any glass goes on the saw. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

A run can measure dead right at both ends and still belly out in the middle, which only appears once the template plots the intermediate points. Cut it square where it should be radiused and the piece will fail on the lift, not in the kitchen. Radiused, polished, and clear of the joins. The range or Aga, the sink and the tap all need to be confirmed by model before nesting, because their clearances and hole positions set where the island can be cut. An owner living in the house makes the decisions and lives with them, so the specification tends to go towards the material rather than towards the lowest total. The workshop works from the approved drawing, so whoever signs it off is signing off the join positions too. The approved drawing is the instruction.