Worktop design and quotation in Gidea Park

Yes. Gidea Park is on the patch, and the postcodes we work here are RM2. It is worked on our east London run, along with the rest of Havering. Off-street parking means the van stays put all day, so tools, packers and the offcut we would rather have than not are all within reach. It sits in the fitting line as time on site rather than as anything to do with the stone. Nothing here is added after the fact. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

A detached house of this age has a drive, a side path and a back door, so access is rarely the constraint and the design can follow the room. Walls between the original room and the extension are frequently out of square, which affects the template but not the price; what does affect it is the appliance list, because a drop-in range, an undermount bowl and a half, a boiling tap and a separate drainer are four separately priced cut-outs. Priced from the building, not from a rate card. Original houses here have thick, irregular walls and out-of-square corners, so we template every wall run individually instead of assuming parallel sides.

Leafy roads with long front drives and mature planting, so the van gets on the plot but the carry from drive to door is longer than average and often over gravel. A short hard approach with no steps means a full-length piece can be walked in flat by two people rather than turned up on edge. An access-driven join is priced like any other join, and people are always surprised to see one on a dead straight run. You see that figure before we template, not after.

Yes. On the research for this patch it is the first of the three jobs listed, ahead of worktop templating and worktop fabrication. A new extension slab is not automatically level, and that wants checking before templating rather than after the stone is cut. Everything is itemised: material, template, fabrication, fitting, each cut-out and each metre of upstand. Nothing payable until we template. The junction between the original room and the extension is the point to watch, because the two floors rarely sit at the same height. That changes what the quote should be compared against, because the shape of the job is not the same as a single family kitchen. Material is the slab only, and it says so.

Seating overhangs past roughly 300mm will not carry on the carcass alone, so flat steel bar or a plywood substrate has to be built into the units first. Slab yield is worked out at quote stage, so if the layout forces a second slab you hear it before you commit rather than after. Shape first, area second. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Where a corner is a couple of degrees off, a mitre cut to a theoretical ninety degrees opens on the wall side and there is no closing it afterwards. Send photographs of every corner of the room and it gets priced properly first time. Better on the quote than in a variation. Send the extension drawing or the unit layout with the actual appliance model numbers, since cut-out sizes come from the appliance, not the cabinet. Where someone is living in the house through the work, the strip-out and the fit are planned so the kitchen is out of use for a day and not a week. Nothing is payable until we template, so a quote can sit while consents and decisions catch up. Nothing payable until template.