Worktop installation in Ham

Yes. Ham is on the patch, and the postcodes we work here are TW10. It is worked on our south west London run, along with the rest of Richmond upon Thames. On a street with no restrictions the constraint is other residents rather than a warden, so it is worth putting a cone or a car out early. The fitting slot is set around it, which is why we ask about it when the date is booked and not before we leave the yard. The day is built around that window. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Walls look modern and are not: block or breeze with a skim that has been patched over decades, so dry-laying and scribing still apply. The fitting itself is about squaring up to walls that look modern and are not: block or breeze walls with a skim that has been patched over decades, so we still dry-lay and scribe rather than trust the template edge. That is the shape of the day. The estate houses have thin partition walls and lightweight carcasses, so weight matters - 20mm quartz or porcelain rather than 30mm granite.

Estate roads with communal parking courts set back from the houses so the carry is 20 to 30 metres, and pedestrian-only paths between blocks that a trolley handles but a van cannot follow. Estate roads are often too tight for a long-wheelbase van to turn, so the carry starts a good deal further from the door than a map suggests. The fitting day is planned backwards from that point, before anything comes off the van. That is what the morning is planned around.

It is one of the three we do most here, behind worktop replacement. Same template visit, same workshop, same installers either way. The junction between the original room and the extension is the point to watch, because the two floors rarely sit at the same height. The fitting day is scheduled to suit that rather than to suit the diary. One visit, done properly. Extension kitchens are usually specified long before they are buildable, so the run lengths on the drawing and the run lengths in the room are different numbers. Where the window is fixed there is no second day to fall back on, so the prep list matters more than usual. Sealed before we leave.

A peninsula is an island with one end tied to a run, which means the join between them has to be planned rather than allowed to happen. On the day that means dry-laying the whole layout first and only then pulling and bonding the joins. Dry-lay first, always. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Taped internal angles in plasterboard belly at the corner, so the run picks up a few millimetres over the last 300mm and a plan-angle mitre will not close. Rushing that is what leaves a gap you look at every morning for fifteen years. Dry-lay, mark, cut, then bond. Unlock any rear or shared path gate and clear both the hall and the back approach so we can choose the better route on the day. The householder is normally on site at template, and that is the right time to settle sink position, tap centres and overhang rather than agree them by email. Floors and units are protected before anything comes through the door, communal or otherwise. One visit, our own installers.