Worktop design and quotation in Ham

Yes. Ham is on the patch, and the postcodes we work here are TW10. It is worked on our south west London run, along with the rest of Richmond upon Thames. On a street with no restrictions the constraint is other residents rather than a warden, so it is worth putting a cone or a car out early. Where a bay suspension or a permit is needed, that is a real cost and it goes on the quote instead of appearing later. You are told before you commit to a date. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Base units from the seventies and eighties are often only 500mm deep, so a 600mm stone top overhangs at the front and the doors want checking against it. With little area to spread them over, the cut-outs and the fixed lines carry the quote, so each is listed on its own. You see it before you commit to anything. The estate houses have thin partition walls and lightweight carcasses, so weight matters - 20mm quartz or porcelain rather than 30mm granite.

Estate roads with communal parking courts set back from the houses so the carry is 20 to 30 metres, and pedestrian-only paths between blocks that a trolley handles but a van cannot follow. The barrier, the entry code and the estate rules decide when a van can get near the door, and none of that is negotiable on the day. That is why the fitting line on a quote reflects manpower and time rather than square metres. Nothing about it gets estimated after the fact.

It is one of the three we do most here, behind worktop replacement. Same template visit, same workshop, same installers either way. The junction between the original room and the extension is the point to watch, because the two floors rarely sit at the same height. Comparing quotes only works when they itemise the same things, and this is where the differences usually hide. Nothing payable until we template. Extension kitchens are usually specified long before they are buildable, so the run lengths on the drawing and the run lengths in the room are different numbers. Everything is itemised: material, template, fabrication, fitting, each cut-out and each metre of upstand. Itemised, so it can be compared honestly.

A peninsula is an island with one end tied to a run, which means the join between them has to be planned rather than allowed to happen. Slab yield is worked out at quote stage, so if the layout forces a second slab you hear it before you commit rather than after. The join count is stated with its reason. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Taped internal angles in plasterboard belly at the corner, so the run picks up a few millimetres over the last 300mm and a plan-angle mitre will not close. Send photographs of every corner of the room and it gets priced properly first time. Priced as fabrication, not as area. Tell us whether there is side or rear access to the kitchen from outside, and send the run lengths with a photo of the window and boiler positions. An owner living in the house makes the decisions and lives with them, so the specification tends to go towards the material rather than towards the lowest total. The quote is written so it can be read by whoever is paying rather than only by whoever is standing in the kitchen. Written to be read by whoever is paying.