Worktop design and quotation in Kingston Vale

Yes. Kingston Vale is on the patch, and the postcodes we work here are SW15. It is worked on our south west London run, along with the rest of Kingston upon Thames. Gravel and block paving both look like hard standing and neither takes a loaded trolley, so the run from tail lift to door gets boarded. It sits in the fitting line as time on site rather than as anything to do with the stone. Nothing here is added after the fact. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

The chimney breast in the corner has usually been left in place, so the run gains a return and two scribed ends. These are typically two runs and a return, often into a rear extension, and the return piece is the awkward one, short, wide and rarely nesting well against the long pieces on the slab, so slab yield rather than total area is what pushes the material line up. That is what the itemised lines are for. Side-alley infills give a room barely 2.2m wide, so a run plus a peninsula is the realistic maximum and the island idea has to go.

The area is squeezed between the A3 and the park gate, so getting in means timing the trunk-road traffic; once off it the streets are quiet with driveways and dropped kerbs, which makes unloading straightforward. A side gate and a back door mean the stone never goes through the house at all, which keeps the dust and most of the risk outside. An access-driven join is priced like any other join, and people are always surprised to see one on a dead straight run. You see that figure before we template, not after.

Yes. On the research for this patch it is the first of the three jobs listed, ahead of worktop installation and worktop replacement. A new extension slab is not automatically level, and that wants checking before templating rather than after the stone is cut. That changes what the quote should be compared against, because the shape of the job is not the same as a single family kitchen. Itemised, so it can be compared honestly. The junction between the original room and the extension is the point to watch, because the two floors rarely sit at the same height. Everything is itemised: material, template, fabrication, fitting, each cut-out and each metre of upstand. Nothing payable until we template.

A galley puts the sink on one side and the hob on the other, which spreads the cut-outs across two pieces instead of weakening one. Slab yield is worked out at quote stage, so if the layout forces a second slab you hear it before you commit rather than after. The join count is stated with its reason. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

A chimney breast left in place splits a wall into two alcoves, and the two are rarely the same width and rarely parallel to each other. This is the item most often left out of a cheaper quote, and it comes back as a variation once the templater has been. Better on the quote than in a variation. Send the extension drawing or the unit layout with the actual appliance model numbers, since cut-out sizes come from the appliance, not the cabinet. Owner-occupied kitchens are usually being done once, which is why the edge profile, the vein direction and where a join falls are worth the conversation. Nothing is payable until we template, so a quote can sit while consents and decisions catch up. Written to be read by whoever is paying.