Worktop fabrication in Harrow on the Hill

Yes. Harrow on the Hill is on the patch, and the postcodes we work here are HA1, HA2. It is worked on our north west London run, along with the rest of Harrow. Without a bay the van ends up on a single yellow with a crew member watching it, which takes a pair of hands off the carry. Where unloading has to happen in one go, the load order is planned so nothing has to come off twice. The load plan follows from it. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Listing and conservation conditions apply to a good number of these, which constrains what can be altered around the kitchen rather than what goes on top of the units. The galley run down a side-return usually measures longer than a slab will give us, so a join is designed in from the start and nested to land over a cabinet gable rather than wherever the material happens to run out. The bench proves it before the van moves. Nothing here is level or square, so allow scribing on every edge and expect to shim the units before the template rather than after.

The steepest and narrowest approach in the borough: single-track sections, no pavement in places, resident-only parking and houses set above the road behind steps. A long uphill carry from wherever the van can legally stop is the normal expectation. Carrying through the house means protecting the whole route first: floor boarded, banister padded, and the front door held open on a wedge rather than by hand. Getting that wrong leaves a finished, machined piece that cannot reach the room, which is a remake rather than a trim. The drawing carries that decision through to the saw.

It is one of the three we do most here, behind worktop templating. Same template visit, same workshop, same installers either way. The junction between the original room and the extension is the point to watch, because the two floors rarely sit at the same height. Cutting several kitchens from different slabs and calling them matched is where firms get caught out. Same slab run, or it is not a match. Extension kitchens are usually specified long before they are buildable, so the run lengths on the drawing and the run lengths in the room are different numbers. Pieces are dry-assembled and checked on the bench before anything is loaded. Proven on the bench before dispatch.

Two parallel runs with a walkway between them is the most efficient shape there is on a slab, because both pieces nest as straight lengths with almost no waste. Pieces are dry-assembled on the bench before dispatch so the corners are known to close before they leave the workshop. The bench proves it before the van does. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Level has to hold across the whole room rather than along one wall, or a floor that falls end to end shows as a step where two pieces meet. Cut it square where it should be radiused and the piece will fail on the lift, not in the kitchen. Radiused, polished, and clear of the joins. The sink and hob need to be on site and the run layout fixed before we start cutting, because moving a hob after the join position is set means recutting the whole piece. Mixed ownership means the decision-maker is not always the person who lets us in, so it is worth being clear early about who signs the quote off. Sink and hob are dry-fitted on the bench before dispatch, whoever supplied them. The approved drawing is the instruction.