Worktop fabrication in West Harrow

Yes. West Harrow is on the patch, and the postcodes we work here are HA1, HA2. It is worked on our north west London run, along with the rest of Harrow. Unrestricted kerbside is straightforward as long as the space in front of the property is actually clear when the van arrives. It rarely changes what we cut, but it does change how the pieces are stacked and strapped for the run out. The load plan follows from it. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

The classic arrangement is the original back room with a later extension bolted onto it, so the kitchen is two ages of building in one room. What does drive the bench work is the knocked-through kitchen-diner: the return worktop and any peninsula are seen end-on from the dining side, so we nest the pieces so the veining carries across the internal corner in the same direction rather than turning through ninety degrees. Every join over a gable, clear of every cut-out. The shared side alley is the deciding factor on these terraces, so confirm the gate width and whether the neighbour's fence can be dropped before promising a single-piece top.

Terraced streets with a few dropped kerbs and mostly free but crowded parking, and side alleys of around 750mm shared with the neighbour, which usually works for a slab on edge if the gate is removable. Garden routes carry their own hazards: a drain cover, a step up to a patio, wet decking, or a lawn that will not take a loaded trolley. So the nesting is worked to the measured route first and to the slab second. It is settled on the bench, not on site.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop replacement, worktop installation and worktop templating. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. A new extension slab is not automatically level, and that wants checking before templating rather than after the stone is cut. Cutting several kitchens from different slabs and calling them matched is where firms get caught out. Proven on the bench before dispatch. The junction between the original room and the extension is the point to watch, because the two floors rarely sit at the same height. Pieces are dry-assembled and checked on the bench before anything is loaded. Nested for the job in front of us.

Galley runs are usually short enough to come out of a single slab, so the material band you choose does more to the total than the room shape does. A join that lands in the wrong place cannot be moved once the cut-outs are machined, so it is settled on the drawing. Every join sits over a gable. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

A run can measure dead right at both ends and still belly out in the middle, which only appears once the template plots the intermediate points. Internal corners are machined with a radius and polished, and kept well clear of any join or cut-out. Radiused, polished, and clear of the joins. The peninsula end detail needs deciding up front - square edge, mitred apron down the end, or a full waterfall - because a waterfall end has to be cut in sequence off the same part of the slab as the top. The householder is normally on site at template, and that is the right time to settle sink position, tap centres and overhang rather than agree them by email. Changing an appliance after the nest is set means recutting the piece, not adjusting it. The approved drawing is the instruction.