Worktop installation in Hatch End

Yes. Hatch End is on the patch, and the postcodes we work here are HA5. It is worked on our north west London run, along with the rest of Harrow. A drive that shelves towards the house needs the van chocked and the trolley controlled, since a loaded A-frame gathers speed quickly on a slope. We aim for the first slot of the day where parking is tight, because that is when the street is emptiest. The day is built around that window. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

The rear extension is frequently original rather than added, which means it is solidly built and just as far out of square as the rest of the house. The day is planned backwards from the hall, and the scribing takes longer than the carry. The slow parts are slow for a reason. Extension kitchens with structural glazing put the run against a wall of glass, so support and edge detail at the glazing line matters more than the material choice.

Suburban roads with wide drives and easy loading, but the newer apartment blocks near the station have gated car parks, barriers and lifts that must be booked, and the railway bridge constrains larger vehicles on some approaches. Estate roads are often too tight for a long-wheelbase van to turn, so the carry starts a good deal further from the door than a map suggests. The fitting day is planned backwards from that point, before anything comes off the van. It gets checked before the first piece is lifted.

Yes. On the research for this patch it is the first of the three jobs listed, ahead of worktop design & quotation and worktop fabrication. Extension kitchens are usually specified long before they are buildable, so the run lengths on the drawing and the run lengths in the room are different numbers. Where the window is fixed there is no second day to fall back on, so the prep list matters more than usual. Sealed before we leave. Rear and side-return extensions are where the islands appear, and an island is the piece that decides whether one slab does the kitchen or two. One visit, with the sink and hob seated and sealed before we leave. The prep list is not optional.

Seating overhangs past roughly 300mm will not carry on the carcass alone, so flat steel bar or a plywood substrate has to be built into the units first. A layout that has been packed and levelled run by run instead of to one datum shows as a step where two pieces meet. Dry-lay first, always. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Sill height gets settled with the template on site, because it is one of the few dimensions nobody has measured before we arrive. On the day it means dry-laying, marking, and cutting the scribe on site before anything is bonded. Dry-lay, mark, cut, then bond. Clear the full hall and stairs route of furniture, bikes, coats and stair-gates, and keep the front door propped and unobstructed for the carry. A street with houses in single occupation next to the same houses cut into flats produces two completely different jobs from the same elevation. The fitting day is arranged with whoever can actually give us access for the whole slot. One visit, our own installers.