Worktop replacement in Ilford

Yes. Ilford is on the patch, and the postcodes we work here are IG1. It is worked on our east London run, along with the rest of Redbridge. Where the bay sits some distance from the core, the carry across the car park is the longest leg of the day and gets boarded and lit. A replacement is a two-way job, with old tops going out and new stone coming in, so the van needs to stay put across the whole day. Old tops out and new stone in, both through the same gap. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Edwardian terraces are wider and taller than the Victorian houses next to them, so the kitchen usually takes a full-width rear room rather than a narrow outrigger. Lath-and-plaster and bowed brickwork mean we template for scribes rather than straight cuts, and each piece is offered up and eased in rather than dropped straight down. Units kept, surface changed, one day. Assume no kerbside parking outside the door, we plan Ilford jobs around a suspension or an early start, and anything over 3m gets checked against the hallway dogleg before it is cut.

Ilford Lane and the roads off Cranbrook Road are permit-controlled and parked solid both sides, so a slab often comes in on foot from a suspended bay round the corner. New-build blocks mean lift access, booked loading bays and a building manager who wants notice in writing. A car that takes 2.4m on the diagonal will not take a three-metre worktop however it is stood, and there is no trimming it on the landing. Worth remembering that the old tops have to come out the way the new ones come in, and a laminate run is easier to remove in one length than to carry in one. It sets what the day actually looks like.

It is one of the three we do most here, behind worktop templating. Same template visit, same workshop, same installers either way. A new extension slab is not automatically level, and that wants checking before templating rather than after the stone is cut. The carcasses have to be sound, because stone is several times the weight of what is coming off. A day, not a project. The junction between the original room and the extension is the point to watch, because the two floors rarely sit at the same height. Old tops out in the morning, new stone down and sealed the same afternoon. A day, not a project.

The catch with a galley is that both runs are seen end-on from the doorway, so any difference in overhang between the two reads immediately. Old laminate has often been holding a run square for years, and taking it off shows what the units were really doing. Carcasses have to be sound first. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

The stone carries the scribe because the wall cannot be persuaded, so back edges are cut oversize and eased in rather than dropped straight down. This is the commonest reason a replacement turns out to need more than a straight swap. Found at template, not on fit day. Have a plumber booked to disconnect the sink, tap and waste first thing and reconnect after we have gone, and clear the hallway and stairs completely so we can carry slabs through the house. Owner-occupied kitchens are usually being done once, which is why the edge profile, the vein direction and where a join falls are worth the conversation. If the carcasses are tired the honest answer is that stone will find that out, and it is better said before than after. Units kept, surface changed.