Worktop fabrication in Kingston Hill

Yes. Kingston Hill is on the patch, and the postcodes we work here are KT2. It is worked on our south west London run, along with the rest of Kingston upon Thames. Off-street parking means the van stays put all day, so tools, packers and the offcut we would rather have than not are all within reach. Where unloading has to happen in one go, the load order is planned so nothing has to come off twice. That is the last thing settled before dispatch. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

These houses usually sit in their own grounds with a long approach, so the carry from van to door is longer than anything inside the building. Access is off a drive and through wide doors, so for once the piece size is not the constraint - the joins that go in are the ones we choose for layout and veining, not the ones the building forces. The bench proves it before the van moves. Gravel drives and front steps mean the trolley stops at the gate, so plan a carry route and protect the front steps before anything comes off the van.

A long steep main road with limited stopping, and side roads with driveways and gravel that a slab trolley sinks into; several properties sit above the road with a flight of front steps. Door width, hall width and the diagonal at the turn are three separate measurements, and it is the diagonal that catches people out. So the nesting is worked to the measured route first and to the slab second. The drawing carries that decision through to the saw.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop design & quotation, worktop installation and worktop templating. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. The junction between the original room and the extension is the point to watch, because the two floors rarely sit at the same height. Pieces are dry-assembled and checked on the bench before anything is loaded. Proven on the bench before dispatch. Extension kitchens are usually specified long before they are buildable, so the run lengths on the drawing and the run lengths in the room are different numbers. So the nesting is planned around it rather than around a standard kitchen. Nested for the job in front of us.

Seating overhangs past roughly 300mm will not carry on the carcass alone, so flat steel bar or a plywood substrate has to be built into the units first. Pieces are dry-assembled on the bench before dispatch so the corners are known to close before they leave the workshop. That is nested before any glass goes on the saw. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

The returns into a breast recess are the tightest scribes in the room, and they are eased in rather than forced. Cut it square where it should be radiused and the piece will fail on the lift, not in the kitchen. Radiused, polished, and clear of the joins. The range or Aga, the sink and the tap all need to be confirmed by model before nesting, because their clearances and hole positions set where the island can be cut. Where someone is living in the house through the work, the strip-out and the fit are planned so the kitchen is out of use for a day and not a week. Changing an appliance after the nest is set means recutting the piece, not adjusting it. Dry-assembled before it leaves.