Worktop fabrication in Coombe (Kingston)

Yes. Coombe (Kingston) is on the patch, and the postcodes we work here are KT2. It is worked on our south west London run, along with the rest of Kingston upon Thames. A drive that shelves towards the house needs the van chocked and the trolley controlled, since a loaded A-frame gathers speed quickly on a slope. Where unloading has to happen in one go, the load order is planned so nothing has to come off twice. It is decided in the yard, not at the kerb. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

The bay at the front and the back addition at the rear were built to different standards, and the kitchen is nearly always in the weaker of the two. The galley run down a side-return usually measures longer than a slab will give us, so a join is designed in from the start and nested to land over a cabinet gable rather than wherever the material happens to run out. The bench proves it before the van moves. These are drawing-office jobs - book-matched islands, mitred 100mm aprons and full-height panels, so the slab is chosen off the rack before templating.

Private gated estate roads with entry codes and a caretaker, long in-and-out driveways with ample standing, and rear garden access wide enough to bring stone round the outside instead of through the house. Sign-in at the gate, a permit on the dash and a named contact are usually wanted before anything comes off the van. The maximum piece length is fixed at drawing stage and every join is placed over a cabinet gable from there. It is settled on the bench, not on site.

It is one of the three we do most here, behind worktop design & quotation. Same template visit, same workshop, same installers either way. Households sharing a house tend to want two prep areas rather than one, which usually means an island as well as a perimeter run. So the nesting is planned around it rather than around a standard kitchen. Same slab run, or it is not a match. A second kitchen or a kitchenette in an annexe is a small job with the same fixed template, fabrication and fitting lines as a large one. Pieces are dry-assembled and checked on the bench before anything is loaded. Nested for the job in front of us.

On a heavily veined stone the island and the run behind it are nested off the same area of slab so the movement relates across the room. Pieces are dry-assembled on the bench before dispatch so the corners are known to close before they leave the workshop. That is nested before any glass goes on the saw. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Where a corner is a couple of degrees off, a mitre cut to a theoretical ninety degrees opens on the wall side and there is no closing it afterwards. The template drawing carries the real geometry through to the saw, and the piece is machined to it rather than trimmed to it later. Radiused, polished, and clear of the joins. The sink and hob need to be on site and the run layout fixed before we start cutting, because moving a hob after the join position is set means recutting the whole piece. The same building type can arrive as a careful one-off kitchen or as a fast turnaround, and the honest answer is that they are priced differently. Changing an appliance after the nest is set means recutting the piece, not adjusting it. Changes cost a piece, not a tweak.