Worktop design and quotation in Lower Morden

Yes. Lower Morden is on the patch, and the postcodes we work here are SM4. It is worked on our south west London run, along with the rest of Merton. A drive that shelves towards the house needs the van chocked and the trolley controlled, since a loaded A-frame gathers speed quickly on a slope. Where a bay suspension or a permit is needed, that is a real cost and it goes on the quote instead of appearing later. It is one line among the others, and it is honest. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

The kitchen is usually a rear room extended into the garden, with the original external wall now standing inside the run. These are typically two runs and a return, often into a rear extension, and the return piece is the awkward one, short, wide and rarely nesting well against the long pieces on the slab, so slab yield rather than total area is what pushes the material line up. That is what the itemised lines are for. Bigger rooms tempt clients into single unbroken lengths, but anything past 3.1m needs a joint or a crane-free carry route that most of these houses cannot offer through the hall.

This is the easiest access in Merton, driveways, level thresholds and unrestricted parking on most roads. Occasional gated or shared private drives need a key or code arranged in advance. Carrying through the house means protecting the whole route first: floor boarded, banister padded, and the front door held open on a wedge rather than by hand. That is why the fitting line on a quote reflects manpower and time rather than square metres. It appears as its own line rather than buried in a rate.

It is one of the three we do most here, behind worktop installation. Same template visit, same workshop, same installers either way. Extension kitchens are usually specified long before they are buildable, so the run lengths on the drawing and the run lengths in the room are different numbers. Comparing quotes only works when they itemise the same things, and this is where the differences usually hide. Itemised, so it can be compared honestly. Rear and side-return extensions are where the islands appear, and an island is the piece that decides whether one slab does the kitchen or two. Everything is itemised: material, template, fabrication, fitting, each cut-out and each metre of upstand. Nothing payable until we template.

The advantage of a U is that every join can be put over a gable in a corner, so nothing lands in the middle of a clear length. Each run is priced on its own line against the supply rate, with the join count and the reason for each join stated. The join count is stated with its reason. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

The returns into a breast recess are the tightest scribes in the room, and they are eased in rather than forced. This is the item most often left out of a cheaper quote, and it comes back as a variation once the templater has been. Priced as fabrication, not as area. Send the extension drawing or the unit layout with the actual appliance model numbers, since cut-out sizes come from the appliance, not the cabinet. Owner-occupied kitchens are usually being done once, which is why the edge profile, the vein direction and where a join falls are worth the conversation. The quote is written so it can be read by whoever is paying rather than only by whoever is standing in the kitchen. Written to be read by whoever is paying.