Worktop fabrication in Lower Morden

Yes. Lower Morden is on the patch, and the postcodes we work here are SM4. It is worked on our south west London run, along with the rest of Merton. Off-street parking means the van stays put all day, so tools, packers and the offcut we would rather have than not are all within reach. It rarely changes what we cut, but it does change how the pieces are stacked and strapped for the run out. It is decided in the yard, not at the kerb. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Houses of this period came with generous garages and utility rooms, so a second short run of stone is often part of the same job. Most of these have a side passage and a back door, so a full-length piece can usually reach the kitchen without being cut down, and the piece sizing is driven by the slab rather than the route. The bench proves it before the van moves. Bigger rooms tempt clients into single unbroken lengths, but anything past 3.1m needs a joint or a crane-free carry route that most of these houses cannot offer through the hall.

This is the easiest access in Merton, driveways, level thresholds and unrestricted parking on most roads. Occasional gated or shared private drives need a key or code arranged in advance. Carrying through the house means protecting the whole route first: floor boarded, banister padded, and the front door held open on a wedge rather than by hand. The maximum piece length is fixed at drawing stage and every join is placed over a cabinet gable from there. The drawing carries that decision through to the saw.

It is one of the three we do most here, behind worktop installation. Same template visit, same workshop, same installers either way. Rear and side-return extensions are where the islands appear, and an island is the piece that decides whether one slab does the kitchen or two. Pieces are dry-assembled and checked on the bench before anything is loaded. Proven on the bench before dispatch. A new extension slab is not automatically level, and that wants checking before templating rather than after the stone is cut. So the nesting is planned around it rather than around a standard kitchen. Nested for the job in front of us.

The advantage of a U is that every join can be put over a gable in a corner, so nothing lands in the middle of a clear length. The nest is laid out around that, with joins placed over cabinet gables and kept clear of every cut-out. Every join sits over a gable. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Alcove pieces get cut oversize on both scribe edges, with the true wall angles carried on the template drawing rather than assumed. Internal corners are machined with a radius and polished, and kept well clear of any join or cut-out. Machined to the real line. The peninsula end detail needs deciding up front - square edge, mitred apron down the end, or a full waterfall - because a waterfall end has to be cut in sequence off the same part of the slab as the top. Where someone is living in the house through the work, the strip-out and the fit are planned so the kitchen is out of use for a day and not a week. Changing an appliance after the nest is set means recutting the piece, not adjusting it. Dry-assembled before it leaves.