Worktop templating in North Ockendon

Yes. North Ockendon is on the patch, and the postcodes we work here are RM14. It is worked on our east London run, along with the rest of Havering. Gravel and block paving both look like hard standing and neither takes a loaded trolley, so the run from tail lift to door gets boarded. The templating visit needs somewhere to stop for two or three hours, which is a different problem from unloading for twenty minutes. It goes on the job sheet for the fitting crew. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Doorways are low and narrow, which is a genuine constraint on piece length before anything else is considered. The island is templated for its overhang, its support and the position of the hob or sink within it, with sockets and any pop-up left where they will genuinely be. No stone is ever cut from a plan. Unmade drives and farm tracks are hard on a loaded van, so we transfer to a trolley at the gate and take the last stretch slowly.

No parking restrictions at all and plenty of hardstanding, but the approach lanes are single-track with soft verges and the properties often sit at the end of a long unmade drive. Even an easy kerbside carry wants the pavement clear at the tail lift, because a three-metre piece on edge has a swing radius nobody expects until it is swinging. The templater measures that route on the same visit, so the drawing leaves site already knowing the maximum piece. It goes on the drawing with the run dimensions.

Yes. On the research for this patch it is the first of the three jobs listed, ahead of worktop fabrication and worktop installation. A kitchen carved out of a larger room sits under whatever the original plan left behind, so the run frequently ends at a blocked doorway or a boxed-in service. Two to three hours on site, with the sink, tap and hob physically present. The room as it is, not as it was drawn.

An island is a single visible piece with four finished edges and no wall to hide against, so it is the piece the whole kitchen is judged on. A layout templated off one wall instead of one datum will not sit right once all the pieces are down together. Real angles, not plan angles. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Where a breast interrupts a long wall the join can often go there, so it reads as a natural break rather than a line in the middle of a worktop. The template plots it as it is, at the exact height the worktop will sit, and the drawing carries that through. Measured at worktop height, nowhere else. All runs and the island carcass fixed down and levelled to one datum, with the sink, tap and hob on site - an island cannot be templated while it is still loose or sitting on packers. The householder is normally on site at template, and that is the right time to settle sink position, tap centres and overhang rather than agree them by email. A template booked hopefully around another trade is the commonest cause of a wasted visit. Fitted, fixed and level, then we come.