Worktop templating in Wennington

Yes. Wennington is on the patch, and the postcodes we work here are RM13. It is worked on our east London run, along with the rest of Havering. Where the van can pull up level with the gate the pieces are handled the fewest times, which is what actually protects them. The templating visit needs somewhere to stop for two or three hours, which is a different problem from unloading for twenty minutes. It goes on the job sheet for the fitting crew. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

A range or an Aga in an original recess is usually immovable, so the run is designed around it and the clearances come from the appliance. The island is templated for its overhang, its support and the position of the hob or sink within it, with sockets and any pop-up left where they will genuinely be. Two to three hours, once the units are in. Small, one-off rooms out here rarely have a single straight wall, so everything is templated in one visit and cut to that template only.

No restrictions and easy standing outside most properties, but it is a long haul from anywhere and the approach roads are exposed and narrow in places. A short hard approach with no steps means a full-length piece can be walked in flat by two people rather than turned up on edge. The templater measures that route on the same visit, so the drawing leaves site already knowing the maximum piece. The template records it along with everything else.

Yes. On the research for this patch it is the first of the three jobs listed, ahead of worktop fabrication and worktop installation. The junction between the original room and the extension is the point to watch, because the two floors rarely sit at the same height. The template visit is booked once the units are genuinely in, not when they are nearly in. Units fitted, fixed and level first.

The catch with a galley is that both runs are seen end-on from the doorway, so any difference in overhang between the two reads immediately. The template records every angle in that shape as it actually is rather than as the plan drew it. Real angles, not plan angles. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Alcove pieces get cut oversize on both scribe edges, with the true wall angles carried on the template drawing rather than assumed. The template plots it as it is, at the exact height the worktop will sit, and the drawing carries that through. Measured at worktop height, nowhere else. All runs and the island carcass fixed down and levelled to one datum, with the sink, tap and hob on site - an island cannot be templated while it is still loose or sitting on packers. An owner living in the house makes the decisions and lives with them, so the specification tends to go towards the material rather than towards the lowest total. The template happens when the units are in, fixed and level, whoever is fitting them. Fitted, fixed and level, then we come.