Worktop fabrication in Old Malden

Yes. Old Malden is on the patch, and the postcodes we work here are KT4. It is worked on our south west London run, along with the rest of Kingston upon Thames. Gravel and block paving both look like hard standing and neither takes a loaded trolley, so the run from tail lift to door gets boarded. It rarely changes what we cut, but it does change how the pieces are stacked and strapped for the run out. The load plan follows from it. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

A detached house of this age has a drive, a side path and a back door, so access is rarely the constraint and the design can follow the room. Most of these have a side passage and a back door, so a full-length piece can usually reach the kitchen without being cut down, and the piece sizing is driven by the slab rather than the route. Settled on the drawing, cut once. Sloping plots mean the extension floor and the original floor rarely match, so worktop heights get set from the units, never from the finished floor.

The area drops towards the Hogsmill, so several roads are on a noticeable slope with sunken driveways; otherwise off-street parking is the norm and side passages are wide enough for a trolley. Garden routes carry their own hazards: a drain cover, a step up to a patio, wet decking, or a lawn that will not take a loaded trolley. Getting that wrong leaves a finished, machined piece that cannot reach the room, which is a remake rather than a trim. The drawing carries that decision through to the saw.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop templating, worktop installation and worktop design & quotation. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. The junction between the original room and the extension is the point to watch, because the two floors rarely sit at the same height. Cutting several kitchens from different slabs and calling them matched is where firms get caught out. Proven on the bench before dispatch. Extension kitchens are usually specified long before they are buildable, so the run lengths on the drawing and the run lengths in the room are different numbers. Pieces are dry-assembled and checked on the bench before anything is loaded. Nested for the job in front of us.

Two parallel runs with a walkway between them is the most efficient shape there is on a slab, because both pieces nest as straight lengths with almost no waste. A join that lands in the wrong place cannot be moved once the cut-outs are machined, so it is settled on the drawing. Every join sits over a gable. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

A low sill over the sink run is what decides between an upstand and stone dying into a window board, and there is often less clearance than an upstand is tall. Cut it square where it should be radiused and the piece will fail on the lift, not in the kitchen. Radiused, polished, and clear of the joins. The peninsula end detail needs deciding up front - square edge, mitred apron down the end, or a full waterfall - because a waterfall end has to be cut in sequence off the same part of the slab as the top. Owner-occupied kitchens are usually being done once, which is why the edge profile, the vein direction and where a join falls are worth the conversation. The workshop works from the approved drawing, so whoever signs it off is signing off the join positions too. The approved drawing is the instruction.