Worktop installation in Old Malden

Yes. Old Malden is on the patch, and the postcodes we work here are KT4. It is worked on our south west London run, along with the rest of Kingston upon Thames. A front drive is the best thing that can happen to a fitting day, because the tail lift comes down within a few metres of the door and nothing is on a clock. The fitting slot is set around it, which is why we ask about it when the date is booked and not before we leave the yard. It is why the arrival time is what it is. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

A detached house of this age has a drive, a side path and a back door, so access is rarely the constraint and the design can follow the room. The fitting itself is slower than the carry: original plaster on the party wall and around the old chimney breast is rarely square to the run, so back scribes get cut on site, and where a return wraps into a breast recess we template that shoulder tight and ease it in. Walked, measured, protected, then lifted. Sloping plots mean the extension floor and the original floor rarely match, so worktop heights get set from the units, never from the finished floor.

The area drops towards the Hogsmill, so several roads are on a noticeable slope with sunken driveways; otherwise off-street parking is the norm and side passages are wide enough for a trolley. Rear access usually lets us fit longer pieces whole, so the join count ends up decided by the slab rather than by the building. We walk the route with a tape and protect it end to end before the first piece is lifted. It gets checked before the first piece is lifted.

It is one of the three we do most here, behind worktop templating. Same template visit, same workshop, same installers either way. The junction between the original room and the extension is the point to watch, because the two floors rarely sit at the same height. One visit, with the sink and hob seated and sealed before we leave. Sealed before we leave. Extension kitchens are usually specified long before they are buildable, so the run lengths on the drawing and the run lengths in the room are different numbers. The fitting day is scheduled to suit that rather than to suit the diary. One visit, done properly.

The catch with a galley is that both runs are seen end-on from the doorway, so any difference in overhang between the two reads immediately. Joins are pulled with suction clamps and finished flush, then colour-matched, which is the last thing done rather than the first. Dry-lay first, always. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Window boards and cills stand proud of the plaster, so the back edge of the top has to be plotted to where the units actually sit rather than to the wall. Rushing that is what leaves a gap you look at every morning for fifteen years. Dry-lay, mark, cut, then bond. Unlock and clear the side gate and back door, and move bins, planters and washing lines out of the alley run. The householder is normally on site at template, and that is the right time to settle sink position, tap centres and overhang rather than agree them by email. A half-day of access is not a fitting day, and it is better to say so at booking than to find out at eleven. Access for the whole slot, or a different day.