Worktop fabrication in Osterley

Yes. Osterley is on the patch, and the postcodes we work here are TW7. It is worked on our west London run, along with the rest of Hounslow. A front drive is the best thing that can happen to a fitting day, because the tail lift comes down within a few metres of the door and nothing is on a clock. It rarely changes what we cut, but it does change how the pieces are stacked and strapped for the run out. The load plan follows from it. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Construction is blockwork with a render or a brick skin, so the walls are reasonably true and take a fixing properly. The bench work is about keeping enough solid material between them - a hob cut-out too near a sink cut-out leaves a narrow bridge that will not survive being lifted, so we either move the appliance positions on the template or split the run and put a join over a gable between the two cut-outs. The bench proves it before the van moves. Those side-return infills are longer than a single slab, so a mitred joint mid-run is standard here rather than something to apologise for.

Wide verged avenues, dropped kerbs and driveways on almost every house, with M4 Junction 3 close by. This is about the easiest access in the borough. The van gets close to the door and the stone comes off the tail lift onto a trolley, which is about the shortest carry we ever get. So the nesting is worked to the measured route first and to the slab second. The drawing carries that decision through to the saw.

It is one of the three we do most here, behind worktop installation. Same template visit, same workshop, same installers either way. Extension kitchens are usually specified long before they are buildable, so the run lengths on the drawing and the run lengths in the room are different numbers. Cutting several kitchens from different slabs and calling them matched is where firms get caught out. Proven on the bench before dispatch. A new extension slab is not automatically level, and that wants checking before templating rather than after the stone is cut. Pieces are dry-assembled and checked on the bench before anything is loaded. Nested for the job in front of us.

The step or level change between the original room and the return is real, and the units need packing before stone goes across it. Pieces are dry-assembled on the bench before dispatch so the corners are known to close before they leave the workshop. Every join sits over a gable. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Floors settle, and once base units are packed and levelled properly the stone sits true while everything else in the room admits it is not. Internal corners are machined with a radius and polished, and kept well clear of any join or cut-out. The drawing decides it, not the fitter. Final appliance positions and the actual sink and hob need to be settled before machining, because on a run this short a few centimetres of movement decides whether the piece can be cut in one. Owner-occupied kitchens are usually being done once, which is why the edge profile, the vein direction and where a join falls are worth the conversation. Sink and hob are dry-fitted on the bench before dispatch, whoever supplied them. Dry-assembled before it leaves.