Worktop fabrication in Lampton

Yes. Lampton is on the patch, and the postcodes we work here are TW3. It is worked on our west London run, along with the rest of Hounslow. Permit hours are what matters, not the permit itself, because a bay that frees up at six in the evening is no use for a template at ten. It rarely changes what we cut, but it does change how the pieces are stacked and strapped for the run out. It is decided in the yard, not at the kerb. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

The rear extension is frequently original rather than added, which means it is solidly built and just as far out of square as the rest of the house. The galley run down a side-return usually measures longer than a slab will give us, so a join is designed in from the start and nested to land over a cabinet gable rather than wherever the material happens to run out. Settled on the drawing, cut once. Conservatory-style rear extensions here have low cill heights, so check the window board clash before you set an upstand height you cannot achieve.

Lampton Road is a busy through route with controlled parking either side of it. Most houses have a drive, but it is usually already holding two cars. Door width, hall width and the diagonal at the turn are three separate measurements, and it is the diagonal that catches people out. So the nesting is worked to the measured route first and to the slab second. It is settled on the bench, not on site.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop installation, worktop replacement and worktop templating. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. Extension kitchens are usually specified long before they are buildable, so the run lengths on the drawing and the run lengths in the room are different numbers. Cutting several kitchens from different slabs and calling them matched is where firms get caught out. Proven on the bench before dispatch. Rear and side-return extensions are where the islands appear, and an island is the piece that decides whether one slab does the kitchen or two. So the nesting is planned around it rather than around a standard kitchen. Same slab run, or it is not a match.

The free end is what needs deciding early: square edge, mitred apron down the end, or a full waterfall to the floor, and a waterfall is cut in sequence off the same part of the slab. The nest is laid out around that, with joins placed over cabinet gables and kept clear of every cut-out. The bench proves it before the van does. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Window boards and cills stand proud of the plaster, so the back edge of the top has to be plotted to where the units actually sit rather than to the wall. The template drawing carries the real geometry through to the saw, and the piece is machined to it rather than trimmed to it later. Radiused, polished, and clear of the joins. The sink and hob need to be on site and the run layout fixed before we start cutting, because moving a hob after the join position is set means recutting the whole piece. The same building type can arrive as a careful one-off kitchen or as a fast turnaround, and the honest answer is that they are priced differently. The workshop works from the approved drawing, so whoever signs it off is signing off the join positions too. The approved drawing is the instruction.