Worktop templating in Lampton

Yes. Lampton is on the patch, and the postcodes we work here are TW3. It is worked on our west London run, along with the rest of Hounslow. Permit hours are what matters, not the permit itself, because a bay that frees up at six in the evening is no use for a template at ten. A templater circling for a space arrives late into a slot that was already tight, and the drawing is what suffers. It goes on the job sheet for the fitting crew. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Edwardian terraces are wider and taller than the Victorian houses next to them, so the kitchen usually takes a full-width rear room rather than a narrow outrigger. Victorian party walls and chimney-breast returns bow along their length, so the template plots the real line rather than assuming a straight one - the template picks up points every few hundred millimetres down the back of the run and the drawing carries that curve through to the saw. Recorded as it is, not as it was drawn. Conservatory-style rear extensions here have low cill heights, so check the window board clash before you set an upstand height you cannot achieve.

Lampton Road is a busy through route with controlled parking either side of it. Most houses have a drive, but it is usually already holding two cars. Everything comes through the front door and down the hall, so the tightest point on the route is usually the newel post at the foot of the stairs. A template taken without walking the route produces a drawing that cuts beautifully and will not go in. The template records it along with everything else.

It is one of the three we do most here, behind worktop installation. Same template visit, same workshop, same installers either way. The junction between the original room and the extension is the point to watch, because the two floors rarely sit at the same height. The template visit is booked once the units are genuinely in, not when they are nearly in. Units fitted, fixed and level first. Rear and side-return extensions are where the islands appear, and an island is the piece that decides whether one slab does the kitchen or two. No stone is ever cut from a plan, which is inconvenient exactly when a programme is tight. Appliances on site, not on order.

The free end is what needs deciding early: square edge, mitred apron down the end, or a full waterfall to the floor, and a waterfall is cut in sequence off the same part of the slab. The template records every angle in that shape as it actually is rather than as the plan drew it. Real angles, not plan angles. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Sill height gets settled with the template on site, because it is one of the few dimensions nobody has measured before we arrive. The template plots it as it is, at the exact height the worktop will sit, and the drawing carries that through. Measured at worktop height, nowhere else. Units fixed and packed level over the sloping floor, walls replastered and dry at their final thickness (tiling and splashbacks go on after the worktop, never before), and the sink, tap and hob physically on site, with a Belfast sink built in and set at its finished height. The same building type can arrive as a careful one-off kitchen or as a fast turnaround, and the honest answer is that they are priced differently. The templater needs the sink, tap and hob on site, and a Belfast sink installed at its final height. Fitted, fixed and level, then we come.