Worktop design and quotation in Oval

Yes. Oval is on the patch, and the postcodes we work here are SE11. It is worked on our south London run, along with the rest of Lambeth. Without a bay the van ends up on a single yellow with a crew member watching it, which takes a pair of hands off the carry. It sits in the fitting line as time on site rather than as anything to do with the stone. Nothing here is added after the fact. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Cornice, picture rails and deep skirting survive in converted rooms, so the run stands off the wall and the back edge follows the units rather than the plaster. The kitchen is usually a long galley in a rear extension or side return, so the run lengths are the first thing we check against slab length, anything beyond roughly three metres either needs a join or a second slab, and that decision alone moves the material figure more than a few extra square metres would. Priced from the building, not from a rate card. Conversion flats here frequently have the kitchen on an upper floor with a boxed soil stack in the corner, so allow for a scribed notch at one end of the run.

Match days close roads and fill every space, so scheduling has to work around the cricket calendar. Permit bays are tight, front gardens are shallow railed areas, and upper flats have a shared stair with a landing turn. Communal stairs get boarded and the handrail padded, and we walk the route with a tape before the first piece leaves the van. That is why the fitting line on a quote reflects manpower and time rather than square metres. It appears as its own line rather than buried in a rate.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop replacement, worktop installation and worktop splashbacks & upstands. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. Conversions put kitchens where the services could be made to reach rather than where they belong, so runs are short and interrupted. That changes what the quote should be compared against, because the shape of the job is not the same as a single family kitchen. Nothing payable until we template. In a converted house the flat entrance and the internal doorway are usually tighter than the communal stairs, and that is easy to overlook. Everything is itemised: material, template, fabrication, fitting, each cut-out and each metre of upstand. Material is the slab only, and it says so.

Because a peninsula is seen from both sides, the underside of any overhang gets the same edge treatment as the top, which is easy to leave out of a spec. Slab yield is worked out at quote stage, so if the layout forces a second slab you hear it before you commit rather than after. No installed rate per square metre, because it is not a real number. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Anything that has to stay accessible, a stopcock, a gas meter, a riser panel, is marked on the template so the stone is cut around it instead of over it. This is the item most often left out of a cheaper quote, and it comes back as a variation once the templater has been. Priced as fabrication, not as area. Send us the run lengths, plus photos taken walking from the pavement through the hall to the kitchen so we can see the door widths and the stair turn. A street with houses in single occupation next to the same houses cut into flats produces two completely different jobs from the same elevation. Nothing is payable until we template, so a quote can sit while consents and decisions catch up. Nothing payable until template.