Kitchen worktops in Oval

Yes. Terraces around the ground have been split into flats more often than not, so the kitchen typically sits in a rear room with a 2.6m run and a return, sometimes opened into the living space with a breakfast bar. Whole houses take a modest rear extension rather than a full-width rebuild because gardens are short. Permit hours are what matters, not the permit itself, because a bay that frees up at six in the evening is no use for a template at ten. Panels come off the van in one trip where possible, since a tall piece handled repeatedly is a piece asking to be chipped. Handling is where these pieces get damaged.

Victorian terrace, Georgian terrace, Edwardian mansion flat and Postwar estate block. The flat entrance door and the internal doorways are usually tighter than the communal stairs, which is the opposite of what most people assume. Lath-and-plaster on the party wall and the chimney breast returns almost never runs true, so a 100mm upstand bedded on silicone is the honest answer here, it rides the bow and hides the junction the worktop can never close on its own. The wall makes that decision, not the brochure.

Match days close roads and fill every space, so scheduling has to work around the cricket calendar. Permit bays are tight, front gardens are shallow railed areas, and upper flats have a shared stair with a landing turn. Weight tells on a staircase more than anywhere else, because there is nowhere to set a piece down mid-flight and no way to change your grip once it is moving. Splashback panels are lighter than a worktop and far more awkward, because a tall thin piece has to be carried on edge and cannot be tilted to clear a turn. Joint positions follow from that.

Worktop replacement, worktop installation and worktop splashbacks & upstands, in that order. A kitchen carved out of a larger room sits under whatever the original plan left behind, so the run frequently ends at a blocked doorway or a boxed-in service. Splashbacks and upstands are cut from the same slab run at the same time, which is the only way the batch actually matches. Same batch, same run, same day. Conversion flats here frequently have the kitchen on an upper floor with a boxed soil stack in the corner, so allow for a scribed notch at one end of the run.

Because a peninsula is seen from both sides, the underside of any overhang gets the same edge treatment as the top, which is easy to leave out of a spec. On the day that means dry-laying the whole layout first and only then pulling and bonding the joins. Dry-lay first, always. A notch around a boxed stack is machined with a radius at the internal corner, because a square inside corner there is exactly where a top will crack. Rushing that is what leaves a gap you look at every morning for fifteen years. Dry-lay, mark, cut, then bond. Material runs from £110 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines rather than rolled into one figure.

Mixed ownership means the decision-maker is not always the person who lets us in, so it is worth being clear early about who signs the quote off. Full-height panels need the wall made good first, which is another trade and another timescale. Decided before fabrication, not after. Tell us the building when you book and the lift, the stair turn and any freeholder notice get built into the day rather than found on it.