Kitchen worktops in Kennington

Yes. Georgian and early Victorian houses have their kitchens at lower-ground level in what were service rooms, so runs follow the original room proportions with a small island or a central table rather than a big open plan. Estate flats nearby have compact separate kitchens with fixed service positions. Enforcement zones rarely accept a trade van unloading stone as an exemption, so this gets sorted before the date is confirmed rather than argued about afterwards. Waste is the part people forget: the old laminate or tired granite has to be walked back to the van and it does not get lighter. Old tops out and new stone in, both through the same gap.

Georgian terrace, Early Victorian terrace, Interwar and postwar estate block and Mansion flat. Rooms are tall with deep window reveals, and a run finishing into a reveal is templated to it rather than assumed square. In most Victorian terraces the kitchen sits in the back addition, so you get a narrow galley with one outside wall and nothing square to work off. What is under the old top is the real question.

Much of the Georgian stock is listed or in a conservation area with a lower-ground entrance down railed area steps that turn sharply at the bottom. Parking is permit-controlled and the northern edge falls close to the congestion charge boundary, so charges need checking by street. Door width, hall width and the diagonal at the turn are three separate measurements, and it is the diagonal that catches people out. With no room to turn, the old top gets cut up in the kitchen instead, which is dusty work and needs the room emptied first. The strip-out is planned around it.

Worktop templating, worktop replacement and worktop installation, in that order. The junction between the original room and the extension is the point to watch, because the two floors rarely sit at the same height. The fitting day is scheduled to suit that rather than to suit the diary. One visit, done properly. Lower-ground rooms in this stock are damp-prone and rarely flat, so the run needs packing and the floor level checked at both ends before any long piece is cut.

Seating overhangs past roughly 300mm will not carry on the carcass alone, so flat steel bar or a plywood substrate has to be built into the units first. Old laminate has often been holding a run square for years, and taking it off shows what the units were really doing. Carcasses have to be sound first. Legs bottoming out on hard concrete or an uneven screed mean the tops of the carcasses are not one plane, and that is picked up at template rather than on fitting day. On the day it means dry-laying, marking, and cutting the scribe on site before anything is bonded. Eased in, never forced. Material runs from £110 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines rather than rolled into one figure.

Consent for the work sits with the freeholder or the managing body, and getting it in writing first avoids a crew arriving to a locked door. A replacement keeps the units and changes the surface, which is the least disruptive way to do this in an occupied property. Sound carcasses are the condition. Tell us the building when you book and the lift, the stair turn and any freeholder notice get built into the day rather than found on it.