Worktop installation in Kennington

Yes. Kennington is on the patch, and the postcodes we work here are SE11. It is worked on our south London run, along with the rest of Lambeth. A controlled parking zone means either a visitor permit sorted in advance or a suspended bay, and a suspension is applied for days ahead rather than on the morning. The fitting slot is set around it, which is why we ask about it when the date is booked and not before we leave the yard. We would rather ask than guess. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Georgian houses put the kitchen in a basement or a rear closet wing, and the stairs down to it are the tightest part of the whole route. The day is planned backwards from the hall, and the scribing takes longer than the carry. That is the shape of the day. Lower-ground rooms in this stock are damp-prone and rarely flat, so the run needs packing and the floor level checked at both ends before any long piece is cut.

Much of the Georgian stock is listed or in a conservation area with a lower-ground entrance down railed area steps that turn sharply at the bottom. Parking is permit-controlled and the northern edge falls close to the congestion charge boundary, so charges need checking by street. Door width, hall width and the diagonal at the turn are three separate measurements, and it is the diagonal that catches people out. The fitting day is planned backwards from that point, before anything comes off the van. It gets checked before the first piece is lifted.

It is one of the three we do most here, behind worktop templating. Same template visit, same workshop, same installers either way. A new extension slab is not automatically level, and that wants checking before templating rather than after the stone is cut. Where the window is fixed there is no second day to fall back on, so the prep list matters more than usual. The prep list is not optional. The junction between the original room and the extension is the point to watch, because the two floors rarely sit at the same height. One visit, with the sink and hob seated and sealed before we leave. Sealed before we leave.

Seating overhangs past roughly 300mm will not carry on the carcass alone, so flat steel bar or a plywood substrate has to be built into the units first. A layout that has been packed and levelled run by run instead of to one datum shows as a step where two pieces meet. Dry-lay first, always. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Level has to hold across the whole room rather than along one wall, or a floor that falls end to end shows as a step where two pieces meet. On the day it means dry-laying, marking, and cutting the scribe on site before anything is bonded. It is the slow part of the day and it should be. Clear the full hall and stairs route of furniture, bikes, coats and stair-gates, and keep the front door propped and unobstructed for the carry. Where a landlord or housing provider is involved there is a specification to meet and a process to follow, and both are settled before a date is offered. A half-day of access is not a fitting day, and it is better to say so at booking than to find out at eleven. Protection goes down first.