Worktop replacement in Parsons Green

Yes. Parsons Green is on the patch, and the postcodes we work here are SW6. It is worked on our west London run, along with the rest of Hammersmith and Fulham. On a street with no restrictions the constraint is other residents rather than a warden, so it is worth putting a cone or a car out early. A replacement is a two-way job, with old tops going out and new stone coming in, so the van needs to stay put across the whole day. The waste run is planned, not improvised. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Cornice, picture rails and deep skirting survive in converted rooms, so the run stands off the wall and the back edge follows the units rather than the plaster. What the old top has been hiding is usually a floor that settled towards the back and units that were never fixed back to the wall. Units kept, surface changed, one day. Measure hall width at the stair balustrade, not the skirting - that projection is what actually stops a 900mm island top.

Wider streets and larger front gardens make kerbside easier, and a good proportion of these houses have a genuine side gate with a clear 900mm-plus alley to the garden, which is the route to take. Where there is no side access the hall is generous but the stair balustrade projects, so measure clear width at the balustrade not at the skirting. The side passage is the measurement that matters, because a piece has to be carried flat down it and then turned in at the back door, and the turn is always tighter than the passage. Worth remembering that the old tops have to come out the way the new ones come in, and a laminate run is easier to remove in one length than to carry in one. The strip-out is planned around it.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop design & quotation, worktop fabrication and worktop installation. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. Party-wall and lease conditions in a converted building set when noisy work can happen, which shapes the fitting day more than the kitchen does. The units stay and only the surface changes, so the whole job is one day rather than a kitchen refit. A day, not a project. Conversions put kitchens where the services could be made to reach rather than where they belong, so runs are short and interrupted. The carcasses have to be sound, because stone is several times the weight of what is coming off. A day, not a project.

On a heavily veined stone the island and the run behind it are nested off the same area of slab so the movement relates across the room. The existing layout is being kept, so the question is whether the old carcasses will take stone in that shape without more support. Carcasses have to be sound first. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Level has to hold across the whole room rather than along one wall, or a floor that falls end to end shows as a step where two pieces meet. This is the commonest reason a replacement turns out to need more than a straight swap. It is the usual surprise, and it is a known one. Have a plumber booked to disconnect the sink, tap and waste first thing and reconnect after we have gone, and clear the hallway and stairs completely so we can carry slabs through the house. The householder is normally on site at template, and that is the right time to settle sink position, tap centres and overhang rather than agree them by email. A replacement keeps the units and changes the surface, which is the least disruptive way to do this in an occupied property. Units kept, surface changed.