Worktop replacement in Pinner Green

Yes. Pinner Green is on the patch, and the postcodes we work here are HA5. It is worked on our north west London run, along with the rest of Harrow. Off-street parking means the van stays put all day, so tools, packers and the offcut we would rather have than not are all within reach. A replacement is a two-way job, with old tops going out and new stone coming in, so the van needs to stay put across the whole day. Old tops out and new stone in, both through the same gap. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

A detached house of this age has a drive, a side path and a back door, so access is rarely the constraint and the design can follow the room. The kitchen is normally the original back room with a later side-return or rear extension bolted on, and that helps us: most pieces can go down the side alley and in through the back door in one length, so we can avoid joins that a front-door route would force. What is under the old top is the real question. Older customers often keep a freestanding cooker, so the worktop must finish with a clean polished edge each side of the gap rather than a factory-cut end.

Wide quiet roads with drives and low kerbs, no through traffic, and plenty of space to work off the tail lift on the plot itself. Where the lift will not take the longest run we design a join in rather than gamble, because a piece that will not go up has to go back on the van. We plan the strip-out and the carry as one movement so the kitchen is only out of use for a single day. The strip-out is planned around it.

Yes. On the research for this patch it is the first of the three jobs listed, ahead of worktop installation and worktop design & quotation. Rear and side-return extensions are where the islands appear, and an island is the piece that decides whether one slab does the kitchen or two. Old tops out in the morning, new stone down and sealed the same afternoon. A day, not a project. A new extension slab is not automatically level, and that wants checking before templating rather than after the stone is cut. The units stay and only the surface changes, so the whole job is one day rather than a kitchen refit. A day, not a project.

The free end is what needs deciding early: square edge, mitred apron down the end, or a full waterfall to the floor, and a waterfall is cut in sequence off the same part of the slab. The existing layout is being kept, so the question is whether the old carcasses will take stone in that shape without more support. The units stay, the surface changes. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Alcove pieces get cut oversize on both scribe edges, with the true wall angles carried on the template drawing rather than assumed. This is the commonest reason a replacement turns out to need more than a straight swap. Found at template, not on fit day. Unlock the side gate and clear the alley of bins, bikes and pots, and arrange a plumber for the sink and an electrician if the hob is hard-wired. Where someone is living in the house through the work, the strip-out and the fit are planned so the kitchen is out of use for a day and not a week. If the carcasses are tired the honest answer is that stone will find that out, and it is better said before than after. Sound carcasses are the condition.