Worktop templating in Plaistow

Yes. Plaistow is on the patch, and the postcodes we work here are E13. It is worked on our east London run, along with the rest of Newham. Underground loading has a height restriction, and a van with an A-frame on it is taller than the driver remembers. The templating visit needs somewhere to stop for two or three hours, which is a different problem from unloading for twenty minutes. Two hours is the realistic figure. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Deep original skirting is often left in behind the units, standing them off the wall, so the back edge of the stone is plotted where the carcasses actually sit. Victorian party walls and chimney-breast returns bow along their length, so the template plots the real line rather than assuming a straight one - the template picks up points every few hundred millimetres down the back of the run and the drawing carries that curve through to the saw. Recorded as it is, not as it was drawn. Old outside-WC returns leave a stepped wall in the kitchen, and that step is the single most commonly mis-measured thing in these houses.

Dense terraced streets with front gardens but almost no off-street parking, and permit restrictions during the working day mean a dispensation is usually needed to park across a bay for the fit. Hallways are narrow with a stair rising immediately from the front door, so a 3m piece has to be angled in and walked through on edge. A narrow entrance hall with a turn into the back of the house caps the longest piece we can physically get in, whatever the run itself measures. A template taken without walking the route produces a drawing that cuts beautifully and will not go in. It goes on the drawing with the run dimensions.

Yes. On the research for this patch it is the first of the three jobs listed, ahead of worktop replacement and worktop installation. The junction between the original room and the extension is the point to watch, because the two floors rarely sit at the same height. The template visit is booked once the units are genuinely in, not when they are nearly in. Units fitted, fixed and level first.

Galley runs are usually short enough to come out of a single slab, so the material band you choose does more to the total than the room shape does. The template records every angle in that shape as it actually is rather than as the plan drew it. Real angles, not plan angles. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Where a corner is a couple of degrees off, a mitre cut to a theoretical ninety degrees opens on the wall side and there is no closing it afterwards. It is recorded on the drawing with the run dimensions so the workshop is not guessing. Plotted, not estimated. Units fixed and packed level over the sloping floor, walls replastered and dry at their final thickness (tiling and splashbacks go on after the worktop, never before), and the sink, tap and hob physically on site, with a Belfast sink built in and set at its finished height. Managed stock usually comes with its own rules about working hours, waste, and who is allowed on site. The template happens when the units are in, fixed and level, whoever is fitting them. Fitted, fixed and level, then we come.